- Copy stable/10@285827 to releng/10.2 in preparation for 10.2-RC1
builds.
- Update newvers.sh to reflect RC1.
- Update __FreeBSD_version to reflect 10.2.
- Update default pkg(8) configuration to use the quarterly branch.[1]

Discussed with: re, portmgr [1]
Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Copy head (r256279) to stable/10 as part of the 10.0-RELEASE cycle.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Do a sweep of the tree replacing calls to pci_find_extcap() with calls to
pci_find_cap() instead.

Add support for the new I350 family of 1G interfaces.
- this also includes virtualization support on these devices

Correct some vlan issues we were seeing in test, jumbo frames on vlans
did not work correctly, this was all due to confused logic around HW
filters, the new code should now work for all uses.

Important fix: when mbuf resources are depeleted, it was possible to
completely empty the RX ring, and then the RX engine would stall
forever. This is fixed by a flag being set whenever the refresh code
fails due to an mbuf shortage, also the local timer now makes sure
that all queues get an interrupt when it runs, the interrupt code
will then always call rxeof, and in that routine the first thing done
is now to check the refresh flag and call refresh_mbufs. This has been
verified to fix this type 'hang'. Similar code will follow in the other
drivers.

Finally, sync up shared code for the I350 support.

Thanks to everyone that has been reporting issues, and helping in the
debug/test process!!

Updates for both the em and igb drivers, add support
for multiqueue tx, shared code updates, new device
support, and some bug fixes.

This delta is primarily a fix for es2lan devices that
will sometimes fail to initialize problem due to a lock
contention with management hardware. However, in order to
deliver that fix it was necessary to take a shared code
update as a whole, and this required scattered changes in
the core code to be compatible.

The em driver now has VLAN HW support added as the igb
driver had previously.

MFC after: ASAP - in time for 7.1 RELEASE

Merge of the source for igb and em into dev/e1000, this
proved to be necessary to make the static drivers work
in EITHER/OR or BOTH configurations. Modules will still
build in sys/modules/igb or em as before.

This also updates the igb driver for support for the 82576
adapter, adds shared code fixes, and etc....

MFC after: ASAP

This update primarily addresses the ability to have both the em
and the igb driver static in the kernel. But it also reflects
some other bug fixes in my development stream at Intel.
PR 122373 is also fixed in this code.