- Copy stable/10@285827 to releng/10.2 in preparation for 10.2-RC1
builds.
- Update newvers.sh to reflect RC1.
- Update __FreeBSD_version to reflect 10.2.
- Update default pkg(8) configuration to use the quarterly branch.[1]

Discussed with: re, portmgr [1]
Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Copy head (r256279) to stable/10 as part of the 10.0-RELEASE cycle.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Fix the short repeat option code to not flip the option to 0 when
we call this w/ NOVAL set.

Bring over the basic spectral scan framework code from Qualcomm Atheros.

This includes the HAL routines to setup, enable/activate/disable spectral
scan and configure the relevant registers.

This still requires driver interaction to enable spectral scan reporting.
Specifically:

* call ah_spectralConfigure() to configure and enable spectral scan;
* .. there's currently no way to disable spectral scan... that will have
to follow.
* call ah_spectralStart() to force start a spectral report;
* call ah_spectralStop() to force stop an active spectral report.

The spectral scan results appear as PHY errors (type 0x5 on the AR9280,
same as radar) but with the spectral scan bit set (0x10 in the last byte
of the frame) identifying it as a spectral report rather than a radar
FFT report.

Caveats:

* It's likely quite difficult to run spectral _and_ radar at the same
time. Enabling spectral scan disables the radar thresholds but
leaves radar enabled. Thus, the driver (for now) needs to ensure
that only one or the other is enabled.

* .. it needs testing on HT40 mode.

Tested:

* AR9280 in STA mode, HT/20 only

TODO:

* Test on AR9285, AR9287;
* Test in both HT20 and HT40 modes;
* .. all the driver glue.

Obtained from: Qualcomm Atheros