- Copy stable/10@285827 to releng/10.2 in preparation for 10.2-RC1
builds.
- Update newvers.sh to reflect RC1.
- Update __FreeBSD_version to reflect 10.2.
- Update default pkg(8) configuration to use the quarterly branch.[1]

Discussed with: re, portmgr [1]
Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

MFC r266960:

Configure the analog input 7 which, on BBB, is connected to the 3V3B rail
through a voltage divisor (R163 and R164 on page 4 of BBB schematic).

Add a note about this on ti_adc(4) man page. The ti_adc(4) man page will
first appear on 10.1-RELEASE.

Suggested by: Sulev-Madis Silber (ketas)
Manual page reviewed by: brueffer (D127)

Adds the ADC driver for TI AM3xxx SoC family.

The ADC has a 12bit resolution and its raw output can be read via sysctl(8)
interface.

The driver allows the setup of ADC clock, samples average and open delay
(the number of clock cycles to wait before start the conversion).

The TSC_ADC module is set in the general purpose mode (no touchscreen
support).

Tested on Beaglebone-black.

Written based on AM335x TRM.

Adds the ADC driver for TI AM3xxx SoC family.

The ADC has a 12bit resolution and its raw output can be read via sysctl(8)
interface.

The driver allows the setup of ADC clock, samples average and open delay
(the number of clock cycles to wait before start the conversion).

The TSC_ADC module is set in the general purpose mode (no touchscreen
support).

Tested on Beaglebone-black.

Written based on AM335x TRM.

Reviewed by: rpaulo
Approved by: adrian (mentor)
Tested by: me, Brian J. McGovern, Sulev-Madis Silber (ketas)