| #
266198 |
|
15-May-2014 |
ian |
MFC r261803, r261808, r261814, r261815, r261816, r261817, r261818, r261826,
r261848, r261855
On armv6 and later, use the WriteNotRead bit of the fault status register
to decide what protections are required by the faulting access.
Use the right symbols for determining arm architecture. Include the
necessary header file which has the new FAULT_WNR symbol defined in it.
Allow the kernel to be loaded at any 1MiB address. This requirement is
because we use the 1MiB section maps as they only need a single pagetable.
Add function for configuring Vybrid PLL4 (Audio) clock frequency output.
imx6 changes ...
- Fix the definition of the SDHCI_STATE_DAT and SDHCI_STATE_CMD fields,
and add SDHCI_RETUNE_REQUEST. None of these are actually used in the
code yet.
- Write translation code for the SDHCI_PRESENT_STATE register.
Freescale moved some bits around in their version of the register,
adjust things so that the sdhci code sees the standard layout.
- Add standard non-removable and cd-gpios properties to the usdhc
devices. That generates references to gpio devices, so uncomment them
even though there isn't a gpio driver to do anything with them yet.
- Add handling of standard "non-removable" property, and also some
workaround code so that if card detect is wired to a gpio pin, for now
we just treat it the same as non-removable (because there isn't a gpio
driver yet).
- Enable both sdcard slots, but not the sdio-based wifi that we don't
yet have a driver for.
- Remove a couple obsolete function declarations.
|
| #
266085 |
|
14-May-2014 |
ian |
MFC r256839, r256948, r256950, r257299, r257414, r258057, r259090
Add configuration for the Freescale i.MX53 Quick Start Board.
Add the Raspberry Pi BSC (I2C compliant) controller driver.
Add Radxa Rock board (by radxa.com) support.
Digi-CCWMX53: enable ffec and uart, USB.
Add support for Freescale Vybrid Family VF600
Move and rename dwc otg driver to more generic one as it appears to work
for rk3188 SoC based board too.
|