- Copy stable/10@285827 to releng/10.2 in preparation for 10.2-RC1
builds.
- Update newvers.sh to reflect RC1.
- Update __FreeBSD_version to reflect 10.2.
- Update default pkg(8) configuration to use the quarterly branch.[1]

Discussed with: re, portmgr [1]
Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

MFC r276004: Fix the indentation to simplify comparing the ARM config files.

MFC r276003:

Start to clean up the armv6 kernel configs by reducing the diff between
them in the first sections and the later FDT support.

Disable debugging-related options in all ARM kernel configs for stable-10.
This is a direct commit to stable-10. The following options are disabled
in all arm kernel configs:

DEADLKRES
DIAGNOSTIC
INVARIANTS
INVARIANTS_SUPPORT
WITNESS
WITNESS_SKIPSPIN
Approved by: re(gjb)

MFC 263301

In kernel config files, it is supposed to be 'options<space><tab>' not
'options<tab><tab>', per long standing (but recently not so strictly
enforced) convention.

MFC 263245: Make all the comments '# ' and align to same column.

MFC 257774, 256760, 262916, 262905, 262918, 262919, 262920, 262921, 262924,
262925, 262929, 262932, 262935, 262940, 262941, 262942, 262948, 262949,
262950

Strip arm/conf/DEFAULTS down to just items that are mandatory for running
the architecture.

Move all the files named foo/common.c to foo/foo_common.c

Initial cut for DTS on the hl201 board.

Add commented out dts for sam9260ek as well as early printf support.

Make clock optional on uart nodes, then back it out ("I don't know what I
was thinking, but it is lame.")

Set the baud rate if it isn't 0

Make at91_soc_id() public.

Properly round at91 resource on unmapping.

Move AT91 AIC related stuff to own file.

Fix another bug in multicast filtering. i.MX uses 6 bits from MSB in
LE CRC32 for the hash value, not the lowest 6 bits in BE CRC32.

Follow r262916 with one more config file that references a renamed common.c

Remove bogus AT91 define that causes compile errors. Most of the defines
for SAM9X are going away soonish anyway (once FDT works), but until
then...

Remove all dregs of a per-thread undefined-exception-mode stack.

Rework the VFP code that handles demand-based save and restore of state.

Always call vfp_discard() on thread death.

When a thread begins life it doesn't own the VFP hardware state on any cpu.

Make undefined exception entry MP-safe.

MFC r261252, r261279, r261304, r261305, r261322, r261336, r261337, r261338,
r261353

Fix the name of the dts file for the HL201...

When mapping an address, the bsh needs the same offset we do for other things.

Add explicit depends on bus_if.h and device_if.h to avoid a
chicken and egg problem in some compilation environments.

Switch to using PAs rather than VAs for the addresses we map for
devices. This is a nop, except for what's reported by atmelbus for the
resources.

Comment cleanups. Move things around for diff reduction against FDT work.

Copy head (r256279) to stable/10 as part of the 10.0-RELEASE cycle.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Update the root device to be correct for use with crochet.

Enable VFP in the Versatile PB (QEMU) kernel. Tested on QEMU 1.6.0.

Back out r253779 & r253786.

Decouple yarrow from random(4) device.

* Make Yarrow an optional kernel component -- enabled by "YARROW_RNG" option.
The files sha2.c, hash.c, randomdev_soft.c and yarrow.c comprise yarrow.

* random(4) device doesn't really depend on rijndael-*. Yarrow, however, does.

* Add random_adaptors.[ch] which is basically a store of random_adaptor's.
random_adaptor is basically an adapter that plugs in to random(4).
random_adaptor can only be plugged in to random(4) very early in bootup.
Unplugging random_adaptor from random(4) is not supported, and is probably a
bad idea anyway, due to potential loss of entropy pools.
We currently have 3 random_adaptors:
+ yarrow
+ rdrand (ivy.c)
+ nehemeiah

* Remove platform dependent logic from probe.c, and move it into
corresponding registration routines of each random_adaptor provider.
probe.c doesn't do anything other than picking a specific random_adaptor
from a list of registered ones.

* If the kernel doesn't have any random_adaptor adapters present then the
creation of /dev/random is postponed until next random_adaptor is kldload'ed.

* Fix randomdev_soft.c to refer to its own random_adaptor, instead of a
system wide one.

Submitted by: arthurmesh@gmail.com, obrien
Obtained from: Juniper Networks
Reviewed by: obrien

Replace generic ARM11 option with more specific
support for ARM1136 and ARM1176

Submitted by: Daisuke Aoyama <aoyama at peach.ne.jp>
Obtained from: NetBSD

Fix comment to represent actual file purpose

Spotted by: gavin@

Add support for QEMU's version of Versatile Platform Board