- Copy stable/10 (r259064) to releng/10.0 as part of the
10.0-RELEASE cycle.
- Update __FreeBSD_version [1]
- Set branch name to -RC1

[1] 10.0-CURRENT __FreeBSD_version value ended at '55', so
start releng/10.0 at '100' so the branch is started with
a value ending in zero.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Copy head (r256279) to stable/10 as part of the 10.0-RELEASE cycle.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Flesh out the TX power calibration for the AR9287.

I'm assuming for now that the AR9287 is only open-loop TX power control
(as mine is) so I've hard-coded the attach path to fail if the NIC is
not open-loop.

This greatly simplifies the TX calibration path and the amount of code
which needs to be ported over.

This still isn't complete - the rate calculation code still needs to be
ported and it all needs to be glued together.

Obtained from: Linux ath9k

Bring over my AR9287 work in progress.

It isn't linked into the build because it's missing the TX power
and PDADC programming code.

This code is mostly based on the ath9k codebase, compared against
the Atheros codebase as appropriate.

What's implemented:

* probe/attach
* EEPROM board value programming
* RX initial calibration
* radio channel programming
* general MAC / baseband setup
* async fifo setup
* open-loop tx power calibration

What's missing before it can be enabled by default:

* TX power / calibration setting code
* closed-loop tx power calibration routines
* TSF2 handling
* generic timer support from ath9k

Obtained from: Atheros, ath9k