- Copy stable/10 (r259064) to releng/10.0 as part of the
10.0-RELEASE cycle.
- Update __FreeBSD_version [1]
- Set branch name to -RC1

[1] 10.0-CURRENT __FreeBSD_version value ended at '55', so
start releng/10.0 at '100' so the branch is started with
a value ending in zero.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Copy head (r256279) to stable/10 as part of the 10.0-RELEASE cycle.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

When running on armv6, set alignment checking to modulo-4 mode rather
than modulo-8, because clang emits ldrd and strd instructions for
addresses that are only 4-byte aligned

Remove some redundant register loads.

Discussed on: arm@

Initial support of loader(8) for ARM machines running U-Boot.

This uses the common U-Boot support lib (sys/boot/uboot, already used on
FreeBSD/powerpc), and assumes the underlying firmware has the modern API for
stand-alone apps enabled in the config (CONFIG_API).

Only netbooting is supported at the moment.

Obtained from: Marvell, Semihalf