- Copy stable/10 (r259064) to releng/10.0 as part of the
10.0-RELEASE cycle.
- Update __FreeBSD_version [1]
- Set branch name to -RC1

[1] 10.0-CURRENT __FreeBSD_version value ended at '55', so
start releng/10.0 at '100' so the branch is started with
a value ending in zero.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Copy head (r256279) to stable/10 as part of the 10.0-RELEASE cycle.

Approved by: re (implicit)
Sponsored by: The FreeBSD Foundation

Add message when nvd disks are attached and detached.

As part of this commit, add an nvme_strvis() function which borrows
heavily from cam_strvis(). This will allow stripping of
leading/trailing whitespace and also handle unprintable characters
in model/serial numbers. This function goes into a new nvme_util.c
file which is used by both the driver and nvmecontrol.

Sponsored by: Intel
Reviewed by: carl
MFC after: 3 days

Add firmware replacement and activation support to nvmecontrol(8) through
a new firmware command.

NVMe controllers may support up to 7 firmware slots for storing of
different firmware revisions. This new firmware command supports
firmware replacement (i.e. firmware download) with or without immediate
activation, or activation of a previously stored firmware image. It
also supports selection of the firmware slot during replacement
operations, using IDENTIFY information from the controller to
check that the specified slot is valid.

Newly activated firmware does not take effect until the new controller
reset, either via a reboot or separate 'nvmecontrol reset' command to the
same controller.

Submitted by: Joe Golio <joseph.golio@emc.com>
Obtained from: EMC / Isilon Storage Division
MFC after: 3 days

Add log page support to nvmecontrol(8) through a new logpage command.

This includes pretty printers for all of the standard NVMe log pages
(Error, SMART/Health, Firmware), as well as hex output for non-standard
or vendor-specific log pages.

Submitted by: Joe Golio <joseph.golio@emc.com>
Obtained from: EMC / Isilon Storage Division
MFC after: 3 days

Break out code related to the reset command into a separate source file.

Sponsored by: Intel
MFC after: 3 days

Break out code related to the perftest command into a separate file.

Sponsored by: Intel
MFC after: 3 days

Break out code related to the identify command into a separate source file.

Sponsored by: Intel
MFC after: 3 days

Break out code related to the devlist command into a separate source file.

Sponsored by: Intel
MFC after: 3 days

Add nvmecontrol(8) source code and beginnings of a man page to the tree.

Sponsored by: Intel
Contributions from: Joe Golio/EMC <joseph dot golio at emc dot com>