#
256281 |
|
10-Oct-2013 |
gjb |
Copy head (r256279) to stable/10 as part of the 10.0-RELEASE cycle.
Approved by: re (implicit) Sponsored by: The FreeBSD Foundation |
#
255368 |
|
07-Sep-2013 |
jchandra |
Netlogic XLP network driver update
Changes are to - update board and network interface detection logic - fix reading onboard CPLD in little-endian config - print NAE frequency conrrectly for Bx chips - update XAUI config to disable Rx/Tx until interface is up
Submitted by: Venkatesh J V <venkatesh.vivekanandan@broadcom.com>
|
#
238290 |
|
09-Jul-2012 |
jchandra |
Identify Netlogic XLP 8xx B1 chip revisions
Add functions to check for 8xx B0 and 3xx Ax revisions which will be used in network block initialization.
|
#
233545 |
|
27-Mar-2012 |
jchandra |
xlpge : driver for XLP network accelerator
Features: - network driver for the four 10G interfaces and two management ports on XLP 8xx. - Support 4xx and 3xx variants of the processor. - Source code and firmware building for the 16 mips32r2 micro-code engines in the Network Accelerator. - Basic initialization code for Packet ordering Engine.
Submitted by: Prabhath Raman (prabhath at netlogicmicro com) [refactored and fixed up for style by jchandra]
|
#
233542 |
|
27-Mar-2012 |
jchandra |
Support for EEPROM and CPLD on XLP EVP boards.
On XLP evaluation platform, the board information is stored in an I2C eeprom and the network block configuration is available from a CPLD connected to the GBU (NOR flash bus). Add support for both of these.
|
#
225394 |
|
05-Sep-2011 |
jchandra |
MIPS XLP platform code update.
* Update the hardware access register definitions and functions to bring them in line with other Netlogic software. * Update the platform bus to use PCI even for on-chip devices. Add a dummy PCI driver to ignore on-chip devices which do not need driver. * Provide memory and IRQ resource allocation code for on-chip devices which cannot get it from PCI config. * add support for on-chip PCI and USB interfaces. * update conf files, enable pci and retain old MAXCPU until we can support >32 cpus.
Approved by: re(kib), jmallett
|
#
224110 |
|
16-Jul-2011 |
jchandra |
Add MIPS platform files for Netlogic XLP SoC.
Processor, UART, PIC and Messaging Network code. Also add sys/mips/nlm/hal for on-chip device registers.
In collaboration with: Prabhath Raman <prabhathpr at netlogicmicro com>
Approved by: bz(re), jmallett, imp(mips)
|