1@node RIPng, OSPFv2, RIP, Top 2@comment node-name, next, previous, up 3@chapter RIPng 4 5@command{ripngd} supports the RIPng protocol as described in RFC2080. It's an 6IPv6 reincarnation of the RIP protocol. 7 8@menu 9* Invoking ripngd:: 10* ripngd Configuration:: 11* ripngd Terminal Mode Commands:: 12* ripngd Filtering Commands:: 13@end menu 14 15@node Invoking ripngd, ripngd Configuration, RIPng, RIPng 16@comment node-name, next, previous, up 17@section Invoking ripngd 18 19There are no @code{ripngd} specific invocation options. Common options 20can be specified (@pxref{Common Invocation Options}). 21 22@node ripngd Configuration, ripngd Terminal Mode Commands, Invoking ripngd, RIPng 23@comment node-name, next, previous, up 24@section ripngd Configuration 25 26Currently ripngd supports the following commands: 27 28@deffn Command {router ripng} {} 29Enable RIPng. 30@end deffn 31 32@deffn {RIPng Command} {flush_timer @var{time}} {} 33Set flush timer. 34@end deffn 35 36@deffn {RIPng Command} {network @var{network}} {} 37Set RIPng enabled interface by @var{network} 38@end deffn 39 40@deffn {RIPng Command} {network @var{ifname}} {} 41Set RIPng enabled interface by @var{ifname} 42@end deffn 43 44@deffn {RIPng Command} {route @var{network}} {} 45Set RIPng static routing announcement of @var{network}. 46@end deffn 47 48@deffn Command {router zebra} {} 49This command is the default and does not appear in the configuration. 50With this statement, RIPng routes go to the @command{zebra} daemon. 51@end deffn 52 53@node ripngd Terminal Mode Commands, ripngd Filtering Commands, ripngd Configuration, RIPng 54@comment node-name, next, previous, up 55@section ripngd Terminal Mode Commands 56 57@deffn Command {show ip ripng} {} 58@end deffn 59 60@deffn Command {show debugging ripng} {} 61@end deffn 62 63@deffn Command {debug ripng events} {} 64@end deffn 65 66@deffn Command {debug ripng packet} {} 67@end deffn 68 69@deffn Command {debug ripng zebra} {} 70@end deffn 71 72@node ripngd Filtering Commands, , ripngd Terminal Mode Commands, RIPng 73@comment node-name, next, previous, up 74@section ripngd Filtering Commands 75 76@deffn Command {distribute-list @var{access_list} (in|out) @var{ifname}} {} 77You can apply an access-list to the interface using the 78@code{distribute-list} command. @var{access_list} is an access-list 79name. @var{direct} is @samp{in} or @samp{out}. If @var{direct} is 80@samp{in}, the access-list is applied only to incoming packets. 81 82@example 83distribute-list local-only out sit1 84@end example 85@end deffn 86