1#define MMC_REG_STR_STP_CLK 0x00 2#define MMC_REG_STATUS 0x04 3#define MMC_REG_CLK_RATE 0x08 4#define MMC_REG_CMD_DAT_CONT 0x0C 5#define MMC_REG_RES_TO 0x10 6#define MMC_REG_READ_TO 0x14 7#define MMC_REG_BLK_LEN 0x18 8#define MMC_REG_NOB 0x1C 9#define MMC_REG_REV_NO 0x20 10#define MMC_REG_INT_MASK 0x24 11#define MMC_REG_CMD 0x28 12#define MMC_REG_ARGH 0x2C 13#define MMC_REG_ARGL 0x30 14#define MMC_REG_RES_FIFO 0x34 15#define MMC_REG_BUFFER_ACCESS 0x38 16 17#define STR_STP_CLK_IPG_CLK_GATE_DIS (1<<15) 18#define STR_STP_CLK_IPG_PERCLK_GATE_DIS (1<<14) 19#define STR_STP_CLK_ENDIAN (1<<5) 20#define STR_STP_CLK_RESET (1<<3) 21#define STR_STP_CLK_ENABLE (1<<2) 22#define STR_STP_CLK_START_CLK (1<<1) 23#define STR_STP_CLK_STOP_CLK (1<<0) 24#define STATUS_CARD_PRESENCE (1<<15) 25#define STATUS_SDIO_INT_ACTIVE (1<<14) 26#define STATUS_END_CMD_RESP (1<<13) 27#define STATUS_WRITE_OP_DONE (1<<12) 28#define STATUS_DATA_TRANS_DONE (1<<11) 29#define STATUS_WR_CRC_ERROR_CODE_MASK (3<<10) 30#define STATUS_CARD_BUS_CLK_RUN (1<<8) 31#define STATUS_APPL_BUFF_FF (1<<7) 32#define STATUS_APPL_BUFF_FE (1<<6) 33#define STATUS_RESP_CRC_ERR (1<<5) 34#define STATUS_CRC_READ_ERR (1<<3) 35#define STATUS_CRC_WRITE_ERR (1<<2) 36#define STATUS_TIME_OUT_RESP (1<<1) 37#define STATUS_TIME_OUT_READ (1<<0) 38#define STATUS_ERR_MASK 0x2f 39#define CLK_RATE_PRESCALER(x) ((x) & 0x7) 40#define CLK_RATE_CLK_RATE(x) (((x) & 0x7) << 3) 41#define CMD_DAT_CONT_CMD_RESP_LONG_OFF (1<<12) 42#define CMD_DAT_CONT_STOP_READWAIT (1<<11) 43#define CMD_DAT_CONT_START_READWAIT (1<<10) 44#define CMD_DAT_CONT_BUS_WIDTH_1 (0<<8) 45#define CMD_DAT_CONT_BUS_WIDTH_4 (2<<8) 46#define CMD_DAT_CONT_INIT (1<<7) 47#define CMD_DAT_CONT_BUSY (1<<6) 48#define CMD_DAT_CONT_STREAM_BLOCK (1<<5) 49#define CMD_DAT_CONT_WRITE (1<<4) 50#define CMD_DAT_CONT_DATA_ENABLE (1<<3) 51#define CMD_DAT_CONT_RESPONSE_FORMAT_R1 (1) 52#define CMD_DAT_CONT_RESPONSE_FORMAT_R2 (2) 53#define CMD_DAT_CONT_RESPONSE_FORMAT_R3 (3) 54#define CMD_DAT_CONT_RESPONSE_FORMAT_R4 (4) 55#define CMD_DAT_CONT_RESPONSE_FORMAT_R5 (5) 56#define CMD_DAT_CONT_RESPONSE_FORMAT_R6 (6) 57#define INT_MASK_AUTO_CARD_DETECT (1<<6) 58#define INT_MASK_DAT0_EN (1<<5) 59#define INT_MASK_SDIO (1<<4) 60#define INT_MASK_BUF_READY (1<<3) 61#define INT_MASK_END_CMD_RES (1<<2) 62#define INT_MASK_WRITE_OP_DONE (1<<1) 63#define INT_MASK_DATA_TRAN (1<<0) 64#define INT_ALL (0x7f) 65