1Specifying GPIO information for devices 2============================================ 3 41) gpios property 5----------------- 6 7Nodes that makes use of GPIOs should define them using `gpios' property, 8format of which is: <&gpio-controller1-phandle gpio1-specifier 9 &gpio-controller2-phandle gpio2-specifier 10 0 /* holes are permitted, means no GPIO 3 */ 11 &gpio-controller4-phandle gpio4-specifier 12 ...>; 13 14Note that gpio-specifier length is controller dependent. 15 16gpio-specifier may encode: bank, pin position inside the bank, 17whether pin is open-drain and whether pin is logically inverted. 18 19Example of the node using GPIOs: 20 21 node { 22 gpios = <&qe_pio_e 18 0>; 23 }; 24 25In this example gpio-specifier is "18 0" and encodes GPIO pin number, 26and empty GPIO flags as accepted by the "qe_pio_e" gpio-controller. 27 282) gpio-controller nodes 29------------------------ 30 31Every GPIO controller node must have #gpio-cells property defined, 32this information will be used to translate gpio-specifiers. 33 34Example of two SOC GPIO banks defined as gpio-controller nodes: 35 36 qe_pio_a: gpio-controller@1400 { 37 #gpio-cells = <2>; 38 compatible = "fsl,qe-pario-bank-a", "fsl,qe-pario-bank"; 39 reg = <0x1400 0x18>; 40 gpio-controller; 41 }; 42 43 qe_pio_e: gpio-controller@1460 { 44 #gpio-cells = <2>; 45 compatible = "fsl,qe-pario-bank-e", "fsl,qe-pario-bank"; 46 reg = <0x1460 0x18>; 47 gpio-controller; 48 }; 49 50 51