sireg.h revision 1.2
1/* $NetBSD: sireg.h,v 1.2 2024/02/13 13:46:14 thorpej Exp $ */ 2 3/*- 4 * Copyright (c) 2000 The NetBSD Foundation, Inc. 5 * All rights reserved. 6 * 7 * This code is derived from software contributed to The NetBSD Foundation 8 * by Paul Kranenburg. 9 * 10 * Redistribution and use in source and binary forms, with or without 11 * modification, are permitted provided that the following conditions 12 * are met: 13 * 1. Redistributions of source code must retain the above copyright 14 * notice, this list of conditions and the following disclaimer. 15 * 2. Redistributions in binary form must reproduce the above copyright 16 * notice, this list of conditions and the following disclaimer in the 17 * documentation and/or other materials provided with the distribution. 18 * 19 * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS 20 * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED 21 * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR 22 * PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS 23 * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR 24 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF 25 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS 26 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN 27 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 28 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE 29 * POSSIBILITY OF SUCH DAMAGE. 30 */ 31 32/* 33 * Register map for the VME SCSI-3 adapter (si) 34 * The first part of this register map is an NCR5380 35 * SCSI Bus Interface Controller (SBIC). The rest is a 36 * DMA controller and custom logic. 37 */ 38 39 40#if __for_reference_only__ 41/* 42 * Am5380 Register map (no padding). See dev/ic/ncr5380reg.h 43 */ 44struct ncr5380regs { 45 u_char r[8]; 46}; 47 48struct si_regs { 49 struct ncr5380regs sci; 50 51 /* DMA controller registers */ 52 u_short dma_addrh; /* DMA address (VME only) */ 53 u_short dma_addrl; /* (high word, low word) */ 54 u_short dma_counth; /* DMA count (VME only) */ 55 u_short dma_countl; /* (high word, low word) */ 56 57 /* AMD 9516 regs (OBIO only) see am9516.h */ 58 u_short udc_data; /* Am9516, reg data (OBIO only) */ 59 u_short udc_addr; /* Am9516, reg addr (OBIO only) */ 60 61 u_short fifo_data; /* fifo data register */ 62 u_short fifo_count; /* fifo count register */ 63 u_short si_csr; /* si control/status */ 64 u_short bprh; /* VME byte pack high */ 65 u_short bprl; /* VME byte pack low */ 66 u_short iv_am; /* bits 0-7: intr vector */ 67 /* bits 8-13: addr modifier (VME only) */ 68 /* bits 14-15: unused */ 69 u_short fifo_cnt_hi; /* high part of fifo_count (VME only) */ 70 71 /* Whole thing repeats after 32 bytes. */ 72 u_short _space[3]; 73}; 74#endif 75 76/* 77 * Size of NCR5380 registers located at the bottom of the register bank 78 */ 79#define NCR5380REGS_SZ 8 80 81/* 82 * Register definition for the `si' VME controller 83 */ 84#define SIREG_DMA_ADDRH (NCR5380REGS_SZ + 0) /* DMA address, high word */ 85#define SIREG_DMA_ADDRL (NCR5380REGS_SZ + 2) /* DMA address, low word */ 86#define SIREG_DMA_CNTH (NCR5380REGS_SZ + 4) /* DMA count, high word */ 87#define SIREG_DMA_CNTL (NCR5380REGS_SZ + 6) /* DMA count, low word */ 88#define SIREG_UDC_DATA (NCR5380REGS_SZ + 8) /* UDC reg data */ 89#define SIREG_UDC_ADDR (NCR5380REGS_SZ + 10) /* UDC reg addr */ 90#define SIREG_FIFO_DATA (NCR5380REGS_SZ + 12) /* FIFO data */ 91#define SIREG_FIFO_CNT (NCR5380REGS_SZ + 14) /* FIFO count, low word */ 92#define SIREG_CSR (NCR5380REGS_SZ + 16) /* Control/status register */ 93#define SIREG_BPRH (NCR5380REGS_SZ + 18) /* VME byte pack, high word */ 94#define SIREG_BPRL (NCR5380REGS_SZ + 20) /* VME byte pack, low word */ 95#define SIREG_IV_AM (NCR5380REGS_SZ + 22) /* bits 0-7: intr vector; 96 bits 8-13: addr modifier */ 97#define SIREG_FIFO_CNTH (NCR5380REGS_SZ + 24) /* FIFO count, high word */ 98#define SIREG_BANK_SZ (NCR5380REGS_SZ + 26) 99 100/* 101 * Status Register. 102 * Note: 103 * (r) indicates bit is read only. 104 * (rw) indicates bit is read or write. 105 * (v) vme host adaptor interface only. 106 * (o) sun3/50 onboard host adaptor interface only. 107 * (b) both vme and sun3/50 host adaptor interfaces. 108 * 109 * Note 2: because of the historical connections of this VME driver 110 * with the on-board SCSI interfaces found in sun3/50, sun3/60 and sun4/100 111 * systems, the (v), (o) and (b) qualifications are left in for 112 * cross-reference. 113 */ 114#define SI_CSR_DMA_ACTIVE 0x8000 /* (r,o) DMA transfer active */ 115#define SI_CSR_DMA_CONFLICT 0x4000 /* (r,b) reg accessed while DMA'ing */ 116#define SI_CSR_DMA_BUS_ERR 0x2000 /* (r,b) bus error during DMA */ 117#define SI_CSR_ID 0x1000 /* (r,b) 0 for 3/50, 1 for SCSI-3, */ 118 /* 0 if SCSI-3 unmodified */ 119#define SI_CSR_FIFO_FULL 0x0800 /* (r,b) fifo full */ 120#define SI_CSR_FIFO_EMPTY 0x0400 /* (r,b) fifo empty */ 121#define SI_CSR_SBC_IP 0x0200 /* (r,b) sbc interrupt pending */ 122#define SI_CSR_DMA_IP 0x0100 /* (r,b) DMA interrupt pending */ 123#define SI_CSR_LOB 0x00c0 /* (r,v) number of leftover bytes */ 124#define SI_CSR_LOB_THREE 0x00c0 /* (r,v) three leftover bytes */ 125#define SI_CSR_LOB_TWO 0x0080 /* (r,v) two leftover bytes */ 126#define SI_CSR_LOB_ONE 0x0040 /* (r,v) one leftover byte */ 127#define SI_CSR_BPCON 0x0020 /* (rw,v) byte packing control */ 128 /* DMA is in 0=longwords, 1=words */ 129#define SI_CSR_DMA_EN 0x0010 /* (rw,v) DMA/interrupt enable */ 130#define SI_CSR_SEND 0x0008 /* (rw,b) DMA dir, 1=to device */ 131#define SI_CSR_INTR_EN 0x0004 /* (rw,b) interrupts enable */ 132#define SI_CSR_FIFO_RES 0x0002 /* (rw,b) inits fifo, 0=reset */ 133#define SI_CSR_SCSI_RES 0x0001 /* (rw,b) reset sbc and udc, 0=reset */ 134