GENERIC revision 1.31
1# $NetBSD: GENERIC,v 1.31 1999/03/31 15:38:32 minoura Exp $ 2 3# 4# GENERIC 5# 6 7include "arch/x68k/conf/std.x68k" 8 9maxusers 32 10 11## System kernel configuration. See options(4) for more detail. 12 13 14## Options for variants of the m68k MPU 15## you must have at least the correct one; REQUIRED 16options M68030 17options M68040 18options M68060 19 20 21#### System options specific to the x68k port 22 23options EXTENDED_MEMORY # support for >16MB memory 24options FPU_EMULATE # software fpu emulation for MC68030 25options FPSP # floating point emulation for MC68040 26options M060SP # int/fp emulation for MC68060 27options JUPITER # support for "Jupiter-X" accelerator 28options MAPPEDCOPY # use page mapping for large copyin/copyout 29#options ZSCONSOLE,ZSCN_SPEED="9600" # use serial console 30 31 32#### System options that are the same for all ports 33 34## Root device configuration: change the ?'s if you are going to use a 35## nonstandard root partition (other than where the kernel is booted from) 36## and/or nonstandard root type (not ffs or nfs). Normally this can be 37## automagically determined at boot time. 38 39config netbsd root on ? type ? 40#config netbsd root on sd0 type ffs 41 42## RTC is offset from GMT; -540 means JST-9 43options RTC_OFFSET=-540 # hardware clock is this many mins. west of GMT 44 45## System call tracing (see ktrace(1)). 46options KTRACE 47 48## Collect statistics on kernel malloc's and free's. This does have a 49## significant performance hit on slower machines, so it is intended for 50## diagnostic use only. 51#options KMEMSTATS 52 53## System V compatible IPC subsystem. (msgctl(2), semctl(2), and shmctl(2)) 54options SYSVMSG # System V message queues 55options SYSVSEM # System V semaphores 56options SYSVSHM # System V shared memory 57#options SHMMAXPGS=1024 # 1024 pages is the default 58 59## Loadable kernel module support 60#options LKM 61 62## NFS boot options; not supported currently: needs nfsboot program 63#options NFS_BOOT_BOOTPARAM 64#options NFS_BOOT_BOOTP 65#options NFS_BOOT_DHCP 66 67#### Debugging options 68 69## The DDB in-kernel debugger runs at panic (unless DDB_ONPANIC=0), or at 70## serial console break or keyboard reset, where the PROM would normally 71## intercept. DDB_HISTORY_SIZE adds up/down arrow command history. 72#options DDB # kernel dynamic debugger 73#options DDB_HISTORY_SIZE=100 # enable history editing in DDB 74#options DDB_ONPANIC=1 # see also sysctl(8): `ddb.onpanic' 75#options PANICBUTTON # interrupt switch invokes DDB 76 77## You may also use gdb, on another computer connected to this machine over 78## a serial port. Both KGDBDEV and KGDBRATE should be specified; KGDBDEV is 79## a dev_t encoded device number of the serial port to use. 80## KGDB is not supported for now. 81#options KGDB # support for kernel gdb 82#options KGDBDEV=0xc00 # kgdb device number 83#options KGDBRATE=9600 # baud rate 84 85## Compile the kernel with debugging symbols (`netbsd.gdb' is the debug file), 86## such that gdb(1) can be used on a kernel coredump. 87 88#makeoptions DEBUG="-g" 89 90## Adds code to the kernel that does internal consistency checks, and will 91## cause the kernel to panic if corruption of internal data structures 92## is detected. 93#options DIAGNOSTIC # extra kernel sanity checking 94 95## Enable (possibly expensive) debugging code that may also display messages 96## on the system console 97#options DEBUG 98 99## Make SCSI error messages more verbose when explaining their meanings. 100options SCSIVERBOSE 101 102## `INSECURE' turns off the kernel security level (securelevel = 0 always). 103## This allows writing to /dev/mem, loading kernel modules while multi-user, 104## and other insecurities good only for development work. Do not use this 105## option on a production machine. 106#options INSECURE 107 108## Allow non-root users to grab /dev/console with programs such as xconsole. 109## `xconsole' therefore does not need setuid root with this option enabled. 110#options UCONSOLE 111 112## `FDSCRIPTS' allows non-readable but executable scripts by providing a 113## pre-opened opaque file to the script interpreter. `SETUIDSCRIPTS', 114## which implies FDSCRIPTS, allows scripts to be set-user-id using the same 115## opaque file mechanism. Perl calls this "secure setuid scripts." 116 117#options FDSCRIPTS 118#options SETUIDSCRIPTS 119 120## Options for compatibility with previous releases foreign system binaries. 121 122options COMPAT_43 # 4.3BSD system interfaces 123options COMPAT_09 # NetBSD 0.9 binary compatibility 124options COMPAT_10 # NetBSD 1.0 binary compatibility 125options COMPAT_11 # NetBSD 1.1 binary compatibility 126options COMPAT_12 # NetBSD 1.2 binary compatibility 127options COMPAT_13 # NetBSD 1.3 binary compatibility 128#options COMPAT_M68K4K # NetBSD/m68k4k binaries 129#options COMPAT_SUNOS # SunOS 4.x binary compatibility; broken 130#options COMPAT_LINUX # Linux/m68k binary compatibility 131#options EXEC_ELF32 # 32-bit ELF executables (Linux) 132 133## File systems. 134file-system FFS # Berkeley Fast Filesystem 135file-system NFS # Sun NFS-compatible filesystem client 136file-system KERNFS # kernel data-structure filesystem 137file-system NULLFS # NULL layered filesystem 138file-system MFS # memory-based filesystem 139#file-system FDESC # user file descriptor filesystem 140file-system UMAPFS # uid/gid remapping filesystem 141#file-system LFS # Log-based filesystem (still experimental) 142file-system PORTAL # portal filesystem (still experimental) 143file-system PROCFS # /proc 144file-system CD9660 # ISO 9660 + Rock Ridge file system 145file-system UNION # union file system 146file-system MSDOSFS # MS-DOS FAT filesystem(s). 147#file-system ADOSFS # AmigaDOS filesystem 148 149## File system options. 150options NFSSERVER # Sun NFS-compatible filesystem server 151options QUOTA # FFS quotas 152#options FFS_EI # FFS Endian Independent support 153 154## Network protocol support. In most environments, INET is required. 155options INET # IP (Internet Protocol) v4 156options TCP_COMPAT_42 # 4.2BSD IP implementation compatibility 157#options GATEWAY # packet forwarding ("router switch") 158#options MROUTING # packet forwarding of multicast packets 159#options DIRECTED_BROADCAST # allow broadcasts through routers 160#options NS # Xerox NS networking 161#options NSIP # Xerox NS tunneling over IP 162#options ISO,TPIP # OSI networking 163#options EON # OSI tunneling over IP 164#options CCITT,LLC,HDLC # X.25 packet switched protocol 165options NETATALK # AppleTalk (over Ethernet) protocol 166options NTP # Network Time Protocol in-kernel support 167#options PPS_SYNC # Add serial line synchronization for NTP 168#options PFIL_HOOKS # Add pfil(9) hooks, intended for custom LKMs. 169options IPFILTER_LOG # Add ipmon(8) logging for ipfilter device 170#options PPP_BSDCOMP # Add BSD compression to ppp device 171#options PPP_DEFLATE # Add deflate (libz) compression to ppp device 172#options PPP_FILTER # Add active filters for ppp (via bpf) 173 174 175 176#### Device configurations 177 178## Fundamental devices; see also std.x68k 179dmac0 at intio0 addr 0xe84000 # DMA controler 180xel0 at intio0 181opm0 at intio0 addr 0xe90000 # OPM: required for fdc 182 183## Display devices and console 184grfbus0 at mainbus0 # bitmapped displays 185grf0 at grfbus0 # multiplane graphics 186grf1 at grfbus0 # flexible graphics 187 188kbd0 at mfp0 # standard keyboard 189ite0 at grf0 # internal terminal emulator 190#options ITE_KERNEL_ATTR=4 # bold for kernel messages 191 # see /sys/arch/x68k/dev/itevar.h 192pseudo-device pow 2 # software power switch 193 194## floppy disks 195fdc0 at intio0 addr 0xe94000 intr 96 dma 0 dmaintr 100 # floppy controler 196fd* at fdc0 unit ? # builtin floppy drives 197 198## SCSI devices 199scsirom0 at intio0 addr 0xfc0000 # Built-in SCSI BIOS 200scsirom1 at intio0 addr 0xea0020 # External SCSI BIOS 201spc0 at scsirom0 # genuin SCSI 202spc1 at scsirom1 # genuin SCSI 203scsibus* at spc? 204mha0 at scsirom1 # Mankai MK-HA1 (Mach-2) 205scsibus* at mha0 206 207sd* at scsibus? target ? lun ? # SCSI disks 208cd* at scsibus? target ? lun ? # SCSI CD-ROMs 209st* at scsibus? target ? lun ? # SCSI tapes 210#ss* at scsibus? target ? lun ? # SCSI scanners 211ch* at scsibus? target ? lun ? # SCSI changer devices 212#uk* at scsibus? target ? lun ? # SCSI unknown devices 213 214## Serial ports 215zsc0 at intio0 addr 0xe98000 intr 112 216zstty0 at zsc0 channel 0 # built-in RS-232C 217ms0 at zsc0 channel 1 # standard mouse 218#zsc1 at intio0 addr 0xeafc00 intr 113 219#zstty2 at zsc1 channel 0 220#zstty3 at zsc1 channel 1 221#zsc2 at intio0 addr 0xeafc10 intr 114 222#zstty4 at zsc2 channel 0 223#zstty5 at zsc2 channel 1 224 225pseudo-device sram # battery-backuped static RAM 226pseudo-device bell # OPM bell 227 228xcom0 at mainbus0 # NS16550 fast serial 229xcom1 at mainbus0 230 231## Audio device; broken 232#okiadpcm0 at intio0 addr 0xe92000 intr 106 errintr 107 dma 3 233#audio* at okiadpcm* 234 235## Network interfaces 236neptune0 at intio0 addr 0xece000 intr 249 # Neptune-X 237neptune1 at intio0 addr 0xece400 intr 249 # Neptune-X at alt. addr. 238ne0 at neptune? addr 0x300 # NE2000 or clone 239#se0 at scsibus? target ? lun ? # Ether+; broken 240 241 242#### Pseudo devices 243 244## A disk-like interface to files. Can be used to create floppy, CD, 245## miniroot images, etc. 246 247pseudo-device vnd 4 248 249## Concatenated and striped disks; with this, you can create a software-based 250## disk array similar to a "RAID 0" setup. See ccd(4). 251 252#pseudo-device ccd 4 253 254## RAIDframe disk driver: software RAID driver. See raid(4). 255 256#pseudo-device raid 4 257 258## Memory disk device, used on boot floppies with compressed 259## kernel-plus-root-disk images. 260 261#pseudo-device md 1 262 263## Loopback network interface; required 264pseudo-device loop 265 266## SLIP and CSLIP interfaces, for IP over a serial line. 267pseudo-device sl 1 268 269## PPP, the successor to SLIP. See pppd(8). 270pseudo-device ppp 1 271 272## Network "tunnel" device, allowing protocol stacks to run in the userland. 273## This is used by the third-party user-mode "ppp" program, and others. 274pseudo-device tun 4 275 276## Generic L3 over IP tunnel 277#pseudo-device gre 2 # generic L3 over IP tunnel 278 279## Berkeley Packet Filter, required to run RARPD. A generic C-language 280## interface that allows selective examining of incoming packets. 281pseudo-device bpfilter 8 282 283## IP Filter, used in firewall and NAT applications. See ipnat(8) for 284## one example of the use of the IP Filter. 285pseudo-device ipfilter 286 287 288#### Other device configuration 289 290## Pseudo ttys, required for network logins and programs like screen. 291## 32 is a good number for average systems; you may have as many as you 292## like, though 256 is more or less the upper limit. Increasing this 293## number still requires you to run /dev/MAKEDEV to create the files 294## for the ptys. 295pseudo-device pty 32 # pseudo-ttys (for network, etc.) 296 297## Random device, used to implement /dev/random (a source of random noise), 298## and generate randomness for some kernel formulae. 299pseudo-device rnd 300