1/* $NetBSD: lsi64854reg.h,v 1.5 2001/03/29 02:58:39 petrov Exp $ */ 2 3/*- 4 * Copyright (c) 1998 The NetBSD Foundation, Inc. 5 * All rights reserved. 6 * 7 * This code is derived from software contributed to The NetBSD Foundation 8 * by Paul Kranenburg. 9 * 10 * Redistribution and use in source and binary forms, with or without 11 * modification, are permitted provided that the following conditions 12 * are met: 13 * 1. Redistributions of source code must retain the above copyright 14 * notice, this list of conditions and the following disclaimer. 15 * 2. Redistributions in binary form must reproduce the above copyright 16 * notice, this list of conditions and the following disclaimer in the 17 * documentation and/or other materials provided with the distribution. 18 * 19 * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS 20 * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED 21 * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR 22 * PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS 23 * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR 24 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF 25 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS 26 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN 27 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 28 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE 29 * POSSIBILITY OF SUCH DAMAGE. 30 */ 31 32/* 33 * LSI 64854 DMA engine. Contains three independent channels 34 * designed to interface with (a) a NCR539X SCSI controller, 35 * (b) a AM7990 Ethernet controller, (c) Parallel port hardware.. 36 */ 37 38/* 39 * Register offsets to bus handle. 40 */ 41#define L64854_REG_CSR 0 /* Control bits */ 42#define L64854_REG_ADDR 4 /* DMA Address */ 43#define L64854_REG_CNT 8 /* DMA count */ 44#define L64854_REG_CNT_MASK 0x00ffffff /* only 24 bits */ 45#define L64854_REG_ENBAR 12 /* ENET Base register */ 46#define L64854_REG_TEST 12 /* SCSI Test register */ 47#define L64854_REG_HCR 16 /* PP Hardware Configuration */ 48#define L64854_REG_OCR 18 /* PP Operation Configuration */ 49#define L64854_REG_DR 20 /* PP Data register */ 50#define L64854_REG_TCR 21 /* PP Transfer Control */ 51#define L64854_REG_OR 22 /* PP Output register */ 52#define L64854_REG_IR 23 /* PP Input register */ 53#define L64854_REG_ICR 24 /* PP Interrupt Control */ 54 55 56/* 57 * Control bits common to all three channels. 58 */ 59#define L64854_INT_PEND 0x00000001 /* Interrupt pending */ 60#define L64854_ERR_PEND 0x00000002 /* Error pending */ 61#define L64854_DRAINING 0x0000000c /* FIFO draining */ 62#define L64854_INT_EN 0x00000010 /* Interrupt enable */ 63#define L64854_INVALIDATE 0x00000020 /* Invalidate FIFO */ 64#define L64854_SLAVE_ERR 0x00000040 /* Slave access size error */ 65#define L64854_RESET 0x00000080 /* Reset device */ 66#define L64854_WRITE 0x00000100 /* 1: xfer to memory */ 67#define L64854_EN_DMA 0x00000200 /* enable DMA transfers */ 68 69#define L64854_BURST_SIZE 0x000c0000 /* Read/write burst size */ 70#define L64854_BURST_0 0x00080000 /* no bursts (SCSI-only) */ 71#define L64854_BURST_16 0x00000000 /* 16-byte bursts */ 72#define L64854_BURST_32 0x00040000 /* 32-byte bursts */ 73#define L64854_BURST_64 0x000c0000 /* 64-byte bursts (fas) */ 74 75#define L64854_RST_FAS366 0x08000000 /* FAS366 hardware reset */ 76 77#define L64854_DEVID 0xf0000000 /* device ID bits */ 78 79/* 80 * SCSI DMA control bits. 81 */ 82#define D_INT_PEND L64854_INT_PEND /* interrupt pending */ 83#define D_ERR_PEND L64854_ERR_PEND /* error pending */ 84#define D_DRAINING L64854_DRAINING /* fifo draining */ 85#define D_INT_EN L64854_INT_EN /* interrupt enable */ 86#define D_INVALIDATE L64854_INVALIDATE/* invalidate fifo */ 87#define D_SLAVE_ERR L64854_SLAVE_ERR/* slave access size error */ 88#define D_RESET L64854_RESET /* reset scsi */ 89#define D_WRITE L64854_WRITE /* 1 = dev -> mem */ 90#define D_EN_DMA L64854_EN_DMA /* enable DMA requests */ 91#define D_EN_CNT 0x00002000 /* enable byte counter */ 92#define D_TC 0x00004000 /* terminal count */ 93#define D_WIDE_EN 0x00008000 /* enable wide mode SBUS DMA (fas) */ 94#define D_DSBL_CSR_DRN 0x00010000 /* disable fifo drain on csr */ 95#define D_DSBL_SCSI_DRN 0x00020000 /* disable fifo drain on reg */ 96 97#define D_DIAG 0x00100000 /* disable fifo drain on addr */ 98#define D_TWO_CYCLE 0x00200000 /* 2 clocks per transfer */ 99#define D_FASTER 0x00400000 /* 3 clocks per transfer */ 100#define D_TCI_DIS 0x00800000 /* disable intr on D_TC */ 101#define D_EN_NEXT 0x01000000 /* enable auto next address */ 102#define D_DMA_ON 0x02000000 /* enable dma from scsi XXX */ 103#define D_DSBL_PARITY_CHK \ 104 0x02000000 /* disable checking for parity on bus (default 1:fas) */ 105#define D_A_LOADED 0x04000000 /* address loaded */ 106#define D_NA_LOADED 0x08000000 /* next address loaded */ 107#define D_HW_RESET_FAS366 \ 108 0x08000000 /* hardware reset FAS366 (fas) */ 109#define D_DEV_ID L64854_DEVID /* device ID */ 110#define DMAREV_0 0x00000000 /* Sunray DMA */ 111#define DMAREV_ESC 0x40000000 /* DMA ESC array */ 112#define DMAREV_1 0x80000000 /* 'DMA' */ 113#define DMAREV_PLUS 0x90000000 /* 'DMA+' */ 114#define DMAREV_2 0xa0000000 /* 'DMA2' */ 115#define DMAREV_HME 0xb0000000 /* 'HME' */ 116 117/* 118 * revisions 0,1 and ESC have different bits. 119 */ 120#define D_ESC_DRAIN 0x00000040 /* rev0,1,esc: drain fifo */ 121#define D_ESC_R_PEND 0x00000400 /* rev0,1: request pending */ 122#define D_ESC_BURST 0x00000800 /* DMA ESC: 16 byte bursts */ 123#define D_ESC_AUTODRAIN 0x00040000 /* DMA ESC: Auto-drain */ 124 125#define DDMACSR_BITS "\177\020" \ 126 "b\00INT\0b\01ERR\0f\02\02DRAINING\0b\04IEN\0" \ 127 "b\06SLVERR\0b\07RST\0b\10WRITE\0b\11ENDMA\0" \ 128 "b\15ENCNT\0b\16TC\0\b\20DSBL_CSR_DRN\0" \ 129 "b\21DSBL_SCSI_DRN\0f\22\2BURST\0b\25TWOCYCLE\0" \ 130 "b\26FASTER\0b\27TCIDIS\0b\30ENNXT\0b\031DMAON\0" \ 131 "b\32ALOADED\0b\33NALOADED\0" 132 133 134/* 135 * ENET DMA control bits. 136 */ 137#define E_INT_PEND L64854_INT_PEND /* interrupt pending */ 138#define E_ERR_PEND L64854_ERR_PEND /* error pending */ 139#define E_DRAINING L64854_DRAINING /* fifo draining */ 140#define E_INT_EN L64854_INT_EN /* interrupt enable */ 141#define E_INVALIDATE L64854_INVALIDATE/* invalidate fifo */ 142#define E_SLAVE_ERR L64854_SLAVE_ERR/* slave access size error */ 143#define E_RESET L64854_RESET /* reset ENET */ 144#define E_reserved1 0x00000300 /* */ 145#define E_DRAIN 0x00000400 /* force Ecache drain */ 146#define E_DSBL_WR_DRN 0x00000800 /* disable Ecache drain on .. */ 147#define E_DSBL_RD_DRN 0x00001000 /* disable Ecache drain on .. */ 148#define E_reserved2 0x00006000 /* */ 149#define E_ILACC 0x00008000 /* ... */ 150#define E_DSBL_BUF_WR 0x00010000 /* no buffering of slave writes */ 151#define E_DSBL_WR_INVAL 0x00020000 /* no Ecache invalidate on slave writes */ 152 153#define E_reserved3 0x00100000 /* */ 154#define E_LOOP_TEST 0x00200000 /* loopback mode */ 155#define E_TP_AUI 0x00400000 /* 1 for TP, 0 for AUI */ 156#define E_reserved4 0x0c800000 /* */ 157#define E_DEV_ID L64854_DEVID /* ID bits */ 158 159#define EDMACSR_BITS "\177\020" \ 160 "b\00INT\0b\01ERR\0f\02\02DRAINING\0b\04IEN\0" \ 161 "b\06SLVERR\0b\07RST\0b\10WRITE\0b\12DRAIN\0" \ 162 "b\13DSBL_WR_DRN\0b\14DSBL_RD_DRN\0b\17ILACC\0" \ 163 "b\20DSBL_BUF_WR\0b\21DSBL_WR_INVAL\0" \ 164 "b\25LOOPTEST\0b\26TP\0" 165 166/* 167 * PP DMA control bits. 168 */ 169#define P_INT_PEND L64854_INT_PEND /* interrupt pending */ 170#define P_ERR_PEND L64854_ERR_PEND /* error pending */ 171#define P_DRAINING L64854_DRAINING /* fifo draining */ 172#define P_INT_EN L64854_INT_EN /* interrupt enable */ 173#define P_INVALIDATE L64854_INVALIDATE/* invalidate fifo */ 174#define P_SLAVE_ERR L64854_SLAVE_ERR/* slave access size error */ 175#define P_RESET L64854_RESET /* reset PP */ 176#define P_WRITE L64854_WRITE /* 1: xfer to memory */ 177#define P_EN_DMA L64854_EN_DMA /* enable DMA transfers */ 178#define P_reserved1 0x00001c00 /* */ 179#define P_EN_CNT 0x00002000 /* enable counter */ 180#define P_TC 0x00004000 /* terminal count */ 181#define P_reserved2 0x00038000 /* */ 182 183#define P_DIAG 0x00100000 /* ... */ 184#define P_reserved3 0x00600000 /* */ 185#define P_TCI_DIS 0x00800000 /* no interrupt on terminal count */ 186#define P_EN_NEXT 0x01000000 /* enable DMA chaining */ 187#define P_DMA_ON 0x02000000 /* DMA xfers enabled */ 188#define P_A_LOADED 0x04000000 /* addr and byte count valid */ 189#define P_NA_LOADED 0x08000000 /* next addr & count valid but not used */ 190#define P_DEV_ID L64854_DEVID /* ID bits */ 191 192#define PDMACSR_BITS "\177\020" \ 193 "b\00INT\0b\01ERR\0f\02\02DRAINING\0b\04IEN\0" \ 194 "b\06SLVERR\0b\07RST\0b\10WRITE\0b\11ENDMA\0" \ 195 "b\15ENCNT\0b\16TC\0\b\24DIAG\0b\27TCIDIS\0" \ 196 "b\30ENNXT\0b\031DMAON\0b\32ALOADED\0b\33NALOADED\0" 197