1/* SPDX-License-Identifier: GPL-2.0-only */
2/*
3 * Copyright(c) 2007 Intel Corporation. All rights reserved.
4 *
5 * Maintained at www.Open-FCoE.org
6 */
7
8#ifndef _FC_FCP_H_
9#define	_FC_FCP_H_
10
11#include <scsi/scsi.h>
12
13/*
14 * Fibre Channel Protocol for SCSI.
15 * From T10 FCP-3, T10 project 1560-D Rev 4, Sept. 13, 2005.
16 */
17
18/*
19 * fc/fs.h defines FC_TYPE_FCP.
20 */
21
22/*
23 * Service parameter page parameters (word 3 bits) for Process Login.
24 */
25#define	FCP_SPPF_TASK_RETRY_ID	0x0200	/* task retry ID requested */
26#define	FCP_SPPF_RETRY		0x0100	/* retry supported */
27#define	FCP_SPPF_CONF_COMPL	0x0080	/* confirmed completion allowed */
28#define	FCP_SPPF_OVLY_ALLOW	0x0040	/* data overlay allowed */
29#define	FCP_SPPF_INIT_FCN	0x0020	/* initiator function */
30#define	FCP_SPPF_TARG_FCN	0x0010	/* target function */
31#define	FCP_SPPF_RD_XRDY_DIS	0x0002	/* disable XFER_RDY for reads */
32#define	FCP_SPPF_WR_XRDY_DIS	0x0001	/* disable XFER_RDY for writes */
33
34/*
35 * FCP_CMND IU Payload.
36 */
37struct fcp_cmnd {
38	struct scsi_lun	fc_lun;		/* logical unit number */
39	__u8		fc_cmdref;	/* command reference number */
40	__u8		fc_pri_ta;	/* priority and task attribute */
41	__u8		fc_tm_flags;	/* task management flags */
42	__u8		fc_flags;	/* additional len & flags */
43	__u8		fc_cdb[16];	/* base CDB */
44	__be32		fc_dl;		/* data length (must follow fc_cdb) */
45};
46
47#define	FCP_CMND_LEN	32	/* expected length of structure */
48
49struct fcp_cmnd32 {
50	struct scsi_lun	fc_lun;		/* logical unit number */
51	__u8		fc_cmdref;	/* command reference number */
52	__u8		fc_pri_ta;	/* priority and task attribute */
53	__u8		fc_tm_flags;	/* task management flags */
54	__u8		fc_flags;	/* additional len & flags */
55	__u8		fc_cdb[32];	/* base CDB */
56	__be32		fc_dl;		/* data length (must follow fc_cdb) */
57};
58
59#define	FCP_CMND32_LEN	    48	/* expected length of structure */
60#define	FCP_CMND32_ADD_LEN  (16 / 4)	/* Additional cdb length */
61
62/*
63 * fc_pri_ta.
64 */
65#define	FCP_PTA_SIMPLE	    0	/* simple task attribute */
66#define	FCP_PTA_HEADQ	    1	/* head of queue task attribute */
67#define	FCP_PTA_ORDERED     2	/* ordered task attribute */
68#define	FCP_PTA_ACA	    4	/* auto. contingent allegiance */
69#define	FCP_PTA_MASK	    7	/* mask for task attribute field */
70#define	FCP_PRI_SHIFT	    3	/* priority field starts in bit 3 */
71#define	FCP_PRI_RESVD_MASK  0x80	/* reserved bits in priority field */
72
73/*
74 * fc_tm_flags - task management flags field.
75 */
76#define	FCP_TMF_CLR_ACA		0x40	/* clear ACA condition */
77#define	FCP_TMF_TGT_RESET	0x20	/* target reset task management,
78					   deprecated as of FCP-3 */
79#define	FCP_TMF_LUN_RESET	0x10	/* logical unit reset task management */
80#define	FCP_TMF_CLR_TASK_SET	0x04	/* clear task set */
81#define	FCP_TMF_ABT_TASK_SET	0x02	/* abort task set */
82
83/*
84 * fc_flags.
85 *  Bits 7:2 are the additional FCP_CDB length / 4.
86 */
87#define	FCP_CFL_LEN_MASK	0xfc	/* mask for additional length */
88#define	FCP_CFL_LEN_SHIFT	2	/* shift bits for additional length */
89#define	FCP_CFL_RDDATA		0x02	/* read data */
90#define	FCP_CFL_WRDATA		0x01	/* write data */
91
92/*
93 * FCP_TXRDY IU - transfer ready payload.
94 */
95struct fcp_txrdy {
96	__be32		ft_data_ro;	/* data relative offset */
97	__be32		ft_burst_len;	/* burst length */
98	__u8		_ft_resvd[4];	/* reserved */
99};
100
101#define	FCP_TXRDY_LEN	12	/* expected length of structure */
102
103/*
104 * FCP_RESP IU - response payload.
105 *
106 * The response payload comes in three parts: the flags/status, the
107 * sense/response lengths and the sense data/response info section.
108 *
109 * From FCP3r04, note 6 of section 9.5.13:
110 *
111 * Some early implementations presented the FCP_RSP IU without the FCP_RESID,
112 * FCP_SNS_LEN, and FCP_RSP_LEN fields if the FCP_RESID_UNDER, FCP_RESID_OVER,
113 * FCP_SNS_LEN_VALID, and FCP_RSP_LEN_VALID bits were all set to zero. This
114 * non-standard behavior should be tolerated.
115 *
116 * All response frames will always contain the fcp_resp template.  Some
117 * will also include the fcp_resp_len template.
118 *
119 * From Table 23, the FCP_RSP_INFO can either be 4 bytes or 8 bytes, both
120 * are valid length.
121 */
122struct fcp_resp {
123	__u8		_fr_resvd[8];	/* reserved */
124	__be16		fr_retry_delay;	/* retry delay timer */
125	__u8		fr_flags;	/* flags */
126	__u8		fr_status;	/* SCSI status code */
127};
128
129#define	FCP_RESP_LEN	12	/* expected length of structure */
130
131struct fcp_resp_ext {
132	__be32		fr_resid;	/* Residual value */
133	__be32		fr_sns_len;	/* SCSI Sense length */
134	__be32		fr_rsp_len;	/* Response Info length */
135
136	/*
137	 * Optionally followed by RSP info and/or SNS info and/or
138	 * bidirectional read residual length, if any.
139	 */
140};
141
142#define FCP_RESP_EXT_LEN    12  /* expected length of the structure */
143
144struct fcp_resp_rsp_info {
145    __u8      _fr_resvd[3];       /* reserved */
146    __u8      rsp_code;           /* Response Info Code */
147    __u8      _fr_resvd2[4];      /* reserved */
148};
149
150#define FCP_RESP_RSP_INFO_LEN4    4 /* without reserved field */
151#define FCP_RESP_RSP_INFO_LEN8    8 /* with reserved field */
152
153struct fcp_resp_with_ext {
154	struct fcp_resp resp;
155	struct fcp_resp_ext ext;
156};
157
158#define	FCP_RESP_WITH_EXT   (FCP_RESP_LEN + FCP_RESP_EXT_LEN)
159
160/*
161 * fr_flags.
162 */
163#define	FCP_BIDI_RSP	    0x80	/* bidirectional read response */
164#define	FCP_BIDI_READ_UNDER 0x40	/* bidir. read less than requested */
165#define	FCP_BIDI_READ_OVER  0x20	/* DL insufficient for full transfer */
166#define	FCP_CONF_REQ	    0x10	/* confirmation requested */
167#define	FCP_RESID_UNDER     0x08	/* transfer shorter than expected */
168#define	FCP_RESID_OVER	    0x04	/* DL insufficient for full transfer */
169#define	FCP_SNS_LEN_VAL     0x02	/* SNS_LEN field is valid */
170#define	FCP_RSP_LEN_VAL     0x01	/* RSP_LEN field is valid */
171
172/*
173 * rsp_codes
174 */
175enum fcp_resp_rsp_codes {
176	FCP_TMF_CMPL = 0,
177	FCP_DATA_LEN_INVALID = 1,
178	FCP_CMND_FIELDS_INVALID = 2,
179	FCP_DATA_PARAM_MISMATCH = 3,
180	FCP_TMF_REJECTED = 4,
181	FCP_TMF_FAILED = 5,
182	FCP_TMF_INVALID_LUN = 9,
183};
184
185/*
186 * FCP SRR Link Service request - Sequence Retransmission Request.
187 */
188struct fcp_srr {
189	__u8		srr_op;		/* opcode ELS_SRR */
190	__u8		srr_resvd[3];	/* opcode / reserved - must be zero */
191	__be16		srr_ox_id;	/* OX_ID of failed command */
192	__be16		srr_rx_id;	/* RX_ID of failed command */
193	__be32		srr_rel_off;	/* relative offset */
194	__u8		srr_r_ctl;	/* r_ctl for the information unit */
195	__u8		srr_resvd2[3];	/* reserved */
196};
197
198/*
199 * Feature bits in name server FC-4 Features object.
200 */
201#define	FCP_FEAT_TARG	(1 << 0)	/* target function supported */
202#define	FCP_FEAT_INIT	(1 << 1)	/* initiator function supported */
203
204#endif /* _FC_FCP_H_ */
205