1# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
2%YAML 1.2
3---
4$id: http://devicetree.org/schemas/bus/ti-sysc.yaml#
5$schema: http://devicetree.org/meta-schemas/core.yaml#
6
7title: Texas Instruments interconnect target module
8
9maintainers:
10  - Tony Lindgren <tony@atomide.com>
11
12description:
13  Texas Instruments SoCs can have a generic interconnect target module
14  for devices connected to various interconnects such as L3 interconnect
15  using Arteris NoC, and L4 interconnect using Sonics s3220. This module
16  is mostly used for interaction between module and Power, Reset and Clock
17  Manager PRCM. It participates in the OCP Disconnect Protocol, but other
18  than that it is mostly independent of the interconnect.
19
20  Each interconnect target module can have one or more devices connected to
21  it. There is a set of control registers for managing the interconnect target
22  module clocks, idle modes and interconnect level resets.
23
24  The interconnect target module control registers are sprinkled into the
25  unused register address space of the first child device IP block managed by
26  the interconnect target module. Typically the register names are REVISION,
27  SYSCONFIG and SYSSTATUS.
28
29properties:
30  $nodename:
31    pattern: "^target-module(@[0-9a-f]+)?$"
32
33  compatible:
34    oneOf:
35      - items:
36          - enum:
37              - ti,sysc-omap2
38              - ti,sysc-omap4
39              - ti,sysc-omap4-simple
40              - ti,sysc-omap2-timer
41              - ti,sysc-omap4-timer
42              - ti,sysc-omap3430-sr
43              - ti,sysc-omap3630-sr
44              - ti,sysc-omap4-sr
45              - ti,sysc-omap3-sham
46              - ti,sysc-omap-aes
47              - ti,sysc-mcasp
48              - ti,sysc-dra7-mcasp
49              - ti,sysc-usb-host-fs
50              - ti,sysc-dra7-mcan
51              - ti,sysc-pruss
52          - const: ti,sysc
53      - items:
54          - const: ti,sysc
55
56  reg:
57    description:
58      Interconnect target module control registers consisting of
59      REVISION, SYSCONFIG and SYSSTATUS registers as defined in the
60      Technical Reference Manual for the SoC.
61    minItems: 1
62    maxItems: 3
63
64  reg-names:
65    description:
66      Interconnect target module control register names consisting
67      of "rev", "sysc" and "syss".
68    oneOf:
69      - minItems: 1
70        items:
71          - const: rev
72          - const: sysc
73          - const: syss
74      - items:
75          - const: rev
76          - const: syss
77      - enum: [ sysc, syss ]
78
79  power-domains:
80    description: Target module power domain if available.
81    maxItems: 1
82
83  clocks:
84    description:
85      Target module clocks consisting of one functional clock, one
86      interface clock, and up to 8 module specific optional clocks.
87      Some modules may have only the functional clock, and some have
88      no configurable clocks.
89    minItems: 1
90    maxItems: 4
91
92  clock-names:
93    description:
94      Target module clock names like "fck", "ick", "optck1", "optck2"
95      if the clocks are configurable.
96    oneOf:
97      - enum: [ ick, fck, sys_clk ]
98      - items:
99          - const: fck
100          - enum: [ ick, dbclk, osc, sys_clk, dss_clk, ahclkx ]
101      - items:
102          - const: fck
103          - const: phy-clk
104          - const: phy-clk-div
105      - items:
106          - const: fck
107          - const: hdmi_clk
108          - const: sys_clk
109          - const: tv_clk
110      - items:
111          - const: fck
112          - const: ahclkx
113          - const: ahclkr
114
115  resets:
116    description:
117      Target module reset bit in the RSTCTRL register if wired for the module.
118      Note that the other reset bits should be mapped for the child device
119      driver to use.
120    maxItems: 1
121
122  reset-names:
123    description:
124      Target module reset names in the RSTCTRL register, typically named
125      "rstctrl" if only one reset bit is wired for the module.
126    items:
127      - const: rstctrl
128
129  '#address-cells':
130    enum: [ 1, 2 ]
131
132  '#size-cells':
133    enum: [ 1, 2 ]
134
135  ranges: true
136
137  dma-ranges: true
138
139  ti,sysc-mask:
140    description: Mask of supported register bits for the SYSCONFIG register
141    $ref: /schemas/types.yaml#/definitions/uint32
142
143  ti,sysc-midle:
144    description: List of hardware supported idle modes
145    $ref: /schemas/types.yaml#/definitions/uint32-array
146
147  ti,sysc-sidle:
148    description: List of hardware supported idle modes
149    $ref: /schemas/types.yaml#/definitions/uint32-array
150
151  ti,syss-mask:
152    description: Mask of supported register bits for the SYSSTATUS register
153    $ref: /schemas/types.yaml#/definitions/uint32
154
155  ti,sysc-delay-us:
156    description: Delay needed after OCP softreset before accessing SYCONFIG
157    default: 0
158    minimum: 0
159    maximum: 2
160
161  ti,no-reset-on-init:
162    description: Interconnect target module shall not be reset at init
163    type: boolean
164
165  ti,no-idle-on-init:
166    description: Interconnect target module shall not be idled at init
167    type: boolean
168
169  ti,no-idle:
170    description: Interconnect target module shall not be idled
171    type: boolean
172
173  ti,hwmods:
174    description: Interconnect module name to use with legacy hwmod data
175    $ref: /schemas/types.yaml#/definitions/string
176    deprecated: true
177
178required:
179  - compatible
180  - '#address-cells'
181  - '#size-cells'
182  - ranges
183
184additionalProperties:
185  type: object
186
187examples:
188  - |
189    #include <dt-bindings/bus/ti-sysc.h>
190    #include <dt-bindings/clock/omap4.h>
191
192    target-module@2b000 {
193        compatible = "ti,sysc-omap2", "ti,sysc";
194        ti,hwmods = "usb_otg_hs";
195        reg = <0x2b400 0x4>,
196              <0x2b404 0x4>,
197              <0x2b408 0x4>;
198        reg-names = "rev", "sysc", "syss";
199        clocks = <&l3_init_clkctrl OMAP4_USB_OTG_HS_CLKCTRL 0>;
200        clock-names = "fck";
201        ti,sysc-mask = <(SYSC_OMAP2_ENAWAKEUP |
202                         SYSC_OMAP2_SOFTRESET |
203                         SYSC_OMAP2_AUTOIDLE)>;
204        ti,sysc-midle = <SYSC_IDLE_FORCE>,
205                        <SYSC_IDLE_NO>,
206                        <SYSC_IDLE_SMART>;
207        ti,sysc-sidle = <SYSC_IDLE_FORCE>,
208                        <SYSC_IDLE_NO>,
209                        <SYSC_IDLE_SMART>,
210                        <SYSC_IDLE_SMART_WKUP>;
211        ti,syss-mask = <1>;
212        #address-cells = <1>;
213        #size-cells = <1>;
214        ranges = <0 0x2b000 0x1000>;
215    };
216