1/*- 2 * SPDX-License-Identifier: BSD-2-Clause 3 * 4 * Copyright (c) 2002-2009 Sam Leffler, Errno Consulting 5 * All rights reserved. 6 * 7 * Redistribution and use in source and binary forms, with or without 8 * modification, are permitted provided that the following conditions 9 * are met: 10 * 1. Redistributions of source code must retain the above copyright 11 * notice, this list of conditions and the following disclaimer, 12 * without modification. 13 * 2. Redistributions in binary form must reproduce at minimum a disclaimer 14 * similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any 15 * redistribution must be conditioned upon including a substantially 16 * similar Disclaimer requirement for further binary redistribution. 17 * 18 * NO WARRANTY 19 * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS 20 * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT 21 * LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY 22 * AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL 23 * THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY, 24 * OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF 25 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS 26 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER 27 * IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 28 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF 29 * THE POSSIBILITY OF SUCH DAMAGES. 30 */ 31#ifndef __IF_ATH_DEBUG_H__ 32#define __IF_ATH_DEBUG_H__ 33 34#ifdef ATH_DEBUG 35 36enum { 37 ATH_DEBUG_XMIT = 0x000000001ULL, /* basic xmit operation */ 38 ATH_DEBUG_XMIT_DESC = 0x000000002ULL, /* xmit descriptors */ 39 ATH_DEBUG_RECV = 0x000000004ULL, /* basic recv operation */ 40 ATH_DEBUG_RECV_DESC = 0x000000008ULL, /* recv descriptors */ 41 ATH_DEBUG_RATE = 0x000000010ULL, /* rate control */ 42 ATH_DEBUG_RESET = 0x000000020ULL, /* reset processing */ 43 ATH_DEBUG_MODE = 0x000000040ULL, /* mode init/setup */ 44 ATH_DEBUG_BEACON = 0x000000080ULL, /* beacon handling */ 45 ATH_DEBUG_WATCHDOG = 0x000000100ULL, /* watchdog timeout */ 46 ATH_DEBUG_INTR = 0x000001000ULL, /* ISR */ 47 ATH_DEBUG_TX_PROC = 0x000002000ULL, /* tx ISR proc */ 48 ATH_DEBUG_RX_PROC = 0x000004000ULL, /* rx ISR proc */ 49 ATH_DEBUG_BEACON_PROC = 0x000008000ULL, /* beacon ISR proc */ 50 ATH_DEBUG_CALIBRATE = 0x000010000ULL, /* periodic calibration */ 51 ATH_DEBUG_KEYCACHE = 0x000020000ULL, /* key cache management */ 52 ATH_DEBUG_STATE = 0x000040000ULL, /* 802.11 state transitions */ 53 ATH_DEBUG_NODE = 0x000080000ULL, /* node management */ 54 ATH_DEBUG_LED = 0x000100000ULL, /* led management */ 55 ATH_DEBUG_FF = 0x000200000ULL, /* fast frames */ 56 ATH_DEBUG_DFS = 0x000400000ULL, /* DFS processing */ 57 ATH_DEBUG_TDMA = 0x000800000ULL, /* TDMA processing */ 58 ATH_DEBUG_TDMA_TIMER = 0x001000000ULL, /* TDMA timer processing */ 59 ATH_DEBUG_REGDOMAIN = 0x002000000ULL, /* regulatory processing */ 60 ATH_DEBUG_SW_TX = 0x004000000ULL, /* per-packet software TX */ 61 ATH_DEBUG_SW_TX_BAW = 0x008000000ULL, /* BAW handling */ 62 ATH_DEBUG_SW_TX_CTRL = 0x010000000ULL, /* queue control */ 63 ATH_DEBUG_SW_TX_AGGR = 0x020000000ULL, /* aggregate TX */ 64 ATH_DEBUG_SW_TX_RETRIES = 0x040000000ULL, /* software TX retries */ 65 ATH_DEBUG_FATAL = 0x080000000ULL, /* fatal errors */ 66 ATH_DEBUG_SW_TX_BAR = 0x100000000ULL, /* BAR TX */ 67 ATH_DEBUG_EDMA_RX = 0x200000000ULL, /* RX EDMA state */ 68 ATH_DEBUG_SW_TX_FILT = 0x400000000ULL, /* SW TX FF */ 69 ATH_DEBUG_NODE_PWRSAVE = 0x800000000ULL, /* node powersave */ 70 ATH_DEBUG_DIVERSITY = 0x1000000000ULL, /* Diversity logic */ 71 ATH_DEBUG_PWRSAVE = 0x2000000000ULL, 72 ATH_DEBUG_BTCOEX = 0x4000000000ULL, /* BT Coex */ 73 ATH_DEBUG_QUIETIE = 0x8000000000ULL, /* Quiet time handling */ 74 75 ATH_DEBUG_ANY = 0xffffffffffffffffULL 76}; 77 78enum { 79 ATH_KTR_RXPROC = 0x00000001, 80 ATH_KTR_TXPROC = 0x00000002, 81 ATH_KTR_TXCOMP = 0x00000004, 82 ATH_KTR_SWQ = 0x00000008, 83 ATH_KTR_INTERRUPTS = 0x00000010, 84 ATH_KTR_ERROR = 0x00000020, 85 ATH_KTR_NODE = 0x00000040, 86 ATH_KTR_TX = 0x00000080, 87}; 88 89#define ATH_KTR(_sc, _km, _kf, ...) do { \ 90 if (sc->sc_ktrdebug & (_km)) \ 91 CTR##_kf(KTR_DEV, __VA_ARGS__); \ 92 } while (0) 93 94extern uint64_t ath_debug; 95 96#define IFF_DUMPPKTS(sc, m) (sc->sc_debug & (m)) 97#define DPRINTF(sc, m, ...) do { \ 98 if (sc->sc_debug & (m)) \ 99 device_printf(sc->sc_dev, __VA_ARGS__); \ 100} while (0) 101#define KEYPRINTF(sc, ix, hk, mac) do { \ 102 if (sc->sc_debug & ATH_DEBUG_KEYCACHE) \ 103 ath_keyprint(sc, __func__, ix, hk, mac); \ 104} while (0) 105 106extern void ath_printrxbuf(struct ath_softc *, const struct ath_buf *bf, 107 u_int ix, int); 108extern void ath_printtxbuf(struct ath_softc *, const struct ath_buf *bf, 109 u_int qnum, u_int ix, int done); 110extern void ath_printtxstatbuf(struct ath_softc *sc, const struct ath_buf *bf, 111 const uint32_t *ds, u_int qnum, u_int ix, int done); 112#else /* ATH_DEBUG */ 113#define ATH_KTR(_sc, _km, _kf, ...) do { } while (0) 114 115#define IFF_DUMPPKTS(sc, m) (0) 116#define DPRINTF(sc, m, fmt, ...) do { \ 117 (void) sc; \ 118} while (0) 119#define KEYPRINTF(sc, k, ix, mac) do { \ 120 (void) sc; \ 121} while (0) 122#endif /* ATH_DEBUG */ 123 124#endif 125