xref: /freebsd-10.2-release/sys/mips/conf/RSPRO.hints

# $FreeBSD: head/sys/mips/conf/RSPRO.hints 235661 2012-05-19 20:11:18Z adrian $

# arge0 mdio bus
hint.argemdio.0.at="nexus0"
hint.argemdio.0.maddr=0x19000000
hint.argemdio.0.msize=0x1000
hint.argemdio.0.order=0

# arge0: dedicated switch port
hint.arge.0.phymask=0x10	# PHY4
hint.arge.0.miimode=3		# RGMII
hint.arge.0.mdio=mdioproxy1	# .. off of the switch mdiobus

# arge1: nail to 1000/full, RGMII - connected to the switch
hint.arge.1.media=1000		# Map to 1000/full
hint.arge.1.fduplex=1		#
hint.arge.1.phymask=0x0		# no directly mapped PHYs
hint.arge.1.miimode=3		# RGMII

hint.arswitch.0.is_7240=0
hint.arswitch.0.numphys=4
hint.arswitch.0.phy4cpu=1
hint.arswitch.0.is_rgmii=1
hint.arswitch.0.is_gmii=0

# Don't flip on anything that isn't already enabled.
# This includes leaving the SPI CS1/CS2 pins as GPIO pins as they're
# not used here.
hint.gpio.0.function_set=0x00000000
hint.gpio.0.function_clear=0x00000000

# These are the GPIO LEDs and buttons which can be software controlled.
hint.gpio.0.pinmask=0x000000ff

# GPIO 0: Pin 1
# GPIO 1: Pin 2
# GPIO 2: RF LED
# GPIO 3: Pin 3
# GPIO 4: Pin 4
# GPIO 5: Pin 5
# GPIO 6: Pin 6
# GPIO 7: Pin 7

# RF led
hint.gpioled.0.at="gpiobus0"
hint.gpioled.0.name="rf"
# pin 2
hint.gpioled.0.pins=0x0004