1228944Sadrian# 2228944Sadrian# $FreeBSD: releng/10.2/sys/mips/conf/ROUTERSTATION.hints 254989 2013-08-28 14:43:04Z loos $ 3228944Sadrian# 4228944Sadrian 5250419Sadrian# arge0 mdio bus 6250419Sadrianhint.argemdio.0.at="nexus0" 7250419Sadrianhint.argemdio.0.maddr=0x19000000 8250419Sadrianhint.argemdio.0.msize=0x1000 9250419Sadrianhint.argemdio.0.order=0 10250419Sadrian 11228944Sadrian# Uncomment this hint for RS (not PRO) 12228944Sadrian# PHY20 = 1 << 20 13228944Sadrianhint.arge.0.phymask=0x100000 14250385Sadrianhint.arge.0.mdio=mdioproxy1 # .. off of the switch mdiobus 15228944Sadrian 16228944Sadrian# should be 100 for RS 17228944Sadrianhint.arge.1.media=100 18228944Sadrianhint.arge.1.fduplex=1 19250385Sadrianhint.arge.1.phymask=0x0 20250385Sadrianhint.arge.1.mdio=mdioproxy1 # .. off of the switch mdiobus 21228944Sadrian 22250385Sadrian# ukswitch 23250385Sadrianhint.ukswitch.0.at="mdio0" 24250385Sadrianhint.ukswitch.0.phymask=0x30000 25250385Sadrian 26254989Sloos# Don't flip on anything that isn't already enabled. 27254989Sloos# This includes leaving the SPI CS1/CS2 pins as GPIO pins as they're 28254989Sloos# not used here. 29254989Slooshint.gpio.0.function_set=0x00000000 30254989Slooshint.gpio.0.function_clear=0x00000000 31254989Sloos 32254989Sloos# These are the GPIO LEDs and buttons which can be software controlled. 33254989Slooshint.gpio.0.pinmask=0x000000ff 34254989Sloos 35254989Sloos# GPIO 0: Pin 1 36254989Sloos# GPIO 1: Pin 2 37254989Sloos# GPIO 2: RF LED 38254989Sloos# GPIO 3: Pin 3 39254989Sloos# GPIO 4: Pin 4 40254989Sloos# GPIO 5: Pin 5 41254989Sloos# GPIO 6: Pin 6 42254989Sloos# GPIO 7: Pin 7 43254989Sloos 44228944Sadrian# RF led 45228944Sadrianhint.gpioled.0.at="gpiobus0" 46228944Sadrianhint.gpioled.0.name="rf" 47228944Sadrian# pin 2 48228944Sadrianhint.gpioled.0.pins=0x0004 49