Copyright (c) 2004 Bruce M. Simpson <bms@spc.org>
Copyright (c) 2004 Darron Broad <darron@kewl.org>
All rights reserved.
Redistribution and use in source and binary forms, with or without
modification, are permitted provided that the following conditions
are met:
1. Redistributions of source code must retain the above copyright
notice, this list of conditions and the following disclaimer.
2. Redistributions in binary form must reproduce the above copyright
notice, this list of conditions and the following disclaimer in the
documentation and/or other materials provided with the distribution.
THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND
ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE
FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
SUCH DAMAGE.
$FreeBSD: releng/10.2/share/man/man9/ieee80211_input.9 233648 2012-03-29 05:02:12Z eadler $
.Dd August 4, 2009 .Dt IEEE80211_INPUT 9 .Os .Sh NAME .Nm ieee80211_input .Nd software 802.11 stack input functions .Sh SYNOPSIS n net80211/ieee80211_var.h .Ft void .Fo ieee80211_input .Fa "struct ieee80211_node *" .Fa "struct mbuf *" .Fa "int rssi" .Fa "int noise" .Fc .Ft void .Fo ieee80211_input_all .Fa "struct ieee80211com *" .Fa "struct mbuf *" .Fa "int rssi" .Fa "int noise" .Fc .Sh DESCRIPTION The .Nm net80211 layer that supports 802.11 device drivers requires that receive processing be single-threaded. Typically this is done using a dedicated driver .Xr taskqueue 9 thread. .Fn ieee80211_input and .Fn ieee80211_input_all process received 802.11 frames and are designed for use in that context; e.g. no driver locks may be held.
p The frame passed up in the .Vt mbuf must have the 802.11 protocol header at the front; all device-specific information and/or PLCP must be removed. Any CRC must be stripped from the end of the frame. The 802.11 protocol header should be 32-bit aligned for optimal performance but receive processing does not require it. If the frame holds a payload and that is not aligned to a 32-bit boundary then the payload will be re-aligned so that it is suitable for processing by protocols such as .Xr ip 4 .
p If a device (such as .Xr ath 4 ) inserts padding after the 802.11 header to align the payload to a 32-bit boundary the .Dv IEEE80211_C_DATAPAD capability must be set. Otherwise header and payload are assumed contiguous in the mbuf chain.
p If a received frame must pass through the A-MPDU receive reorder buffer then the mbuf must be marked with the .Dv M_AMPDU flag. Note that for the moment this is required of all frames received from a station and TID where a Block ACK stream is active, not just A-MPDU aggregates. It is sufficient to check for .Dv IEEE80211_NODE_HT in the .Vt ni_flags of the station's node table entry, any frames that do not require reorder processing will be dispatched with only minimal overhead.
p The .Vt rssi parameter is the Receive Signal Strength Indication of the frame measured in 0.5dBm units relative to the noise floor. The .Vt noise parameter is the best approximation of the noise floor in dBm units at the time the frame was received. RSSI and noise are used by the .Nm net80211 layer to make scanning and roaming decisions in station mode and to do auto channel selection for hostap and similar modes. Otherwise the values are made available to user applications (with the rssi presented as a filtered average over the last ten values and the noise floor the last reported value). .Sh SEE ALSO .Xr ieee80211 9