1# BCM95351BU ddr board 2# Copyright 2006, Broadcom Corporation 3# All Rights Reserved. 4# 5# THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY 6# KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM 7# SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS 8# FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE. 9# $Id: bcm95351bu_ddr.txt,v 1.1.1.1 2008/10/15 03:25:52 james26_jang Exp $ 10boardtype=0x047a 11boardnum=${serno} 12# VLAN + ROBO 13boardflags=0x0110 14# Board revision 1.2 15boardrev=0x12 16 17# MIPS clock frequency in MHz 18clkfreq=200 19 20# 16 MB SDR SDRAM (4 Meg x 16 x 2) 21sdram_init=0x0009 22sdram_config=0x62 23sdram_refresh=0x0000 24sdram_ncdl=0 25 26# Bootloader variables 27dl_ram_addr=a0001000 28os_ram_addr=80001000 29os_flash_addr=bfc40000 30lan_ipaddr=192.168.1.1 31lan_netmask=255.255.255.0 32scratch=a0180000 33boot_wait=on 34reset_gpio=3 35 36# Watchdog timer in ms 37watchdog=3000 38 39# Ethernet w/Robo switch 40et0macaddr=00:90:4c:9c:${maclo} 41et0phyaddr=30 42et0mdcport=0 43 44# Robo switch config (vlan0:LAN, vlan1:WAN) 45vlan0ports=1 2 3 4 5* 46vlan0hwname=et0 47vlan1ports=0 5u 48 49# Bootloader and OS glue 50landevs=vlan0 wl0 wl1 51wandevs=et0 52 53# SES parameters 54gpio2=ses_button 55 56# 57# --- on-chip d11 device --- 58# 59# 802.11g parameters 60sb/7/il0macaddr=00:90:4c:9d:${maclo} 61sb/7/aa0=1 62sb/7/ag0=255 63sb/7/pa0maxpwr=76 64sb/7/pa0itssit=62 65sb/7/pa0b0=0x15c8 66sb/7/pa0b1=0xfa80 67sb/7/pa0b2=0xfe65 68sb/7/opo=12 69 70# LED GPIO assignments 71sb/7/wl0gpio2=0 72 73# misc. parameters 74sb/7/ccode=0 75 76# 77# --- off-chip d11 device --- 78# 79pci/1/1/sromrev=2 80# ALTIQ + HGPA + AB + CCK + AD 81pci/1/1/boardflags=0xa248 82 83# LED GPIO assignments 84pci/1/1/wl0gpio0=2 85pci/1/1/wl0gpio1=0 86pci/1/1/wl0gpio2=4 87 88# misc. parameters 89pci/1/1/ccode=0 90 91