1# BCM95351AGR sdram board 2# Copyright 2006, Broadcom Corporation 3# All Rights Reserved. 4# 5# THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY 6# KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM 7# SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS 8# FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE. 9# $Id: bcm95351agr_a_fake.txt,v 1.1.1.1 2008/10/15 03:25:52 james26_jang Exp $ 10# ----------------------------------------------------------------------- 11# Mods to bcm95351agr.txt for this a-mode "fake nvram" file 12# (We do not yet have a good way to deal with cores on different busses.) 13# 1. move "off-chip d11" parameters ahead of "on-chip d11" parameters 14# 2. remove the "bus spec: pci/1/1/1" from the a-mode parameters 15# 3. change all pa1... to pa0... 16# 4. comment out the first instance of boardflags 17# 5. add a mac address: il0macaddr=00:90:4c:9e:dead 18# ----------------------------------------------------------------------- 19boardtype=0x0470 20boardnum=54 21# VLAN + ROBO 22###boardflags=0x0110 23# Board revision 1.4 24boardrev=0x14 25 26# MIPS clock frequency in MHz 27clkfreq=200 28 29# 16 MB SDR SDRAM (4 Meg x 16 x 2) 30sdram_init=0x2000 31sdram_config=0x22 32sdram_refresh=0x0 33sdram_ncdl=0 34 35# Bootloader variables 36dl_ram_addr=a0001000 37os_ram_addr=80001000 38os_flash_addr=bfc40000 39lan_ipaddr=192.168.1.1 40lan_netmask=255.255.255.0 41scratch=a0180000 42boot_wait=on 43reset_gpio=3 44 45# Watchdog timer in ms 46watchdog=3000 47 48# Ethernet w/Robo switch 49et0macaddr=00:90:4c:9c:${maclo} 50et0phyaddr=30 51et0mdcport=0 52 53# Robo switch config (vlan0:LAN, vlan1:WAN) 54vlan0ports=1 2 3 4 5* 55vlan0hwname=et0 56vlan1ports=0 5u 57 58# Bootloader and OS glue 59landevs=vlan0 wl0 wl1 60wandevs=et0 61 62# SES parameters 63gpio2=ses_button 64 65# 66# --- off-chip d11 device --- 67# 68sromrev=2 69# ALTIQ + HGPA + AB + CCK + AD 70boardflags=0xa248 71 72# single band 802.11a device 73devid=0x431a 74 75# 802.11a parameters 76il0macaddr=00:90:4c:9e:dead 77et1macaddr=00:90:4c:9e:${maclo} 78aa1=1 79ag1=2 80pa0lomaxpwr=60 81pa0himaxpwr=60 82pa0lob0=0x1880 83pa0lob1=0xfcbd 84pa0lob2=0xff4b 85pa0hib0=0x18a8 86pa0hib1=0xfcc1 87pa0hib2=0xff41 88pa0maxpwr=60 89pa0b0=0x184c 90pa0b1=0xfcc3 91pa0b2=0xff40 92pa0itssit=120 93opo=0 94 95# LED GPIO assignments 96wl0gpio0=2 97wl0gpio1=0 98wl0gpio2=4 99 100# misc. parameters 101ccode=0 102 103# 104# --- on-chip d11 device --- 105# 106sb/7/sromrev=2 107# HGPA + AB + CCK + AD 108sb/7/boardflags=0x2248 109 110# single band 802.11b/g device 111sb/7/devid=0x4320 112 113# 802.11g parameters 114sb/7/il0macaddr=00:90:4c:9d:${maclo} 115sb/7/aa0=1 116sb/7/ag0=255 117sb/7/pa0maxpwr=76 118sb/7/pa0itssit=62 119sb/7/pa0b0=0x15c8 120sb/7/pa0b1=0xfa80 121sb/7/pa0b2=0xfe65 122sb/7/opo=12 123 124# LED GPIO assignments 125sb/7/wl0gpio2=0 126 127# misc. parameters 128sb/7/ccode=0 129 130