/freebsd-10.1-release/sys/contrib/dts/arm/ |
H A D | sama5d3xdm.dtsi | 34 board {
|
H A D | at91sam9g20ek_2mmc.dts | 2 * at91sam9g20ek_2mmc.dts - Device Tree file for Atmel at91sam9g20ek 2 MMC board 32 pinctrl_board_mmc0_slot0: mmc0_slot0-board {
|
H A D | at91-foxg20.dts | 2 * at91-foxg20.dts - Device Tree file for Acme Systems FoxG20 board 4 * Based on DT files for at91sam9g20ek evaluation board (AT91SAM9G20 SoC) 95 board { 103 pinctrl_board_mmc0_slot1: mmc0_slot1-board {
|
H A D | at91sam9x5ek.dtsi | 2 * at91sam9x5ek.dtsi - Device Tree file for AT91SAM9x5CM Base board 71 pinctrl_board_mmc0: mmc0-board { 78 pinctrl_board_mmc1: mmc1-board {
|
H A D | pm9g45.dts | 2 * pm9g45.dts - Device Tree file for Ronetix pm9g45 board 42 board { 43 pinctrl_board_nand: nand0-board { 51 pinctrl_board_mmc: mmc0-board {
|
H A D | at91sam9g20ek_common.dtsi | 2 * at91sam9g20ek_common.dtsi - Device Tree file for Atmel at91sam9g20ek board 34 board { 43 pinctrl_board_mmc0_slot1: mmc0_slot1-board {
|
/freebsd-10.1-release/sys/arm/at91/ |
H A D | board_bwct.c | 32 #include <machine/board.h> 44 * I don't know anything at all about this board.
|
H A D | board_hl200.c | 32 #include <machine/board.h>
|
H A D | board_eb9200.c | 32 #include <machine/board.h>
|
H A D | board_kb920x.c | 32 #include <machine/board.h>
|
H A D | board_sn9g45.c | 36 #include <machine/board.h>
|
H A D | board_tsc4370.c | 32 #include <machine/board.h> 52 at91rm9200_config_mci(0); /* tsc4370 board has only 1 wire */
|
H A D | board_hl201.c | 32 #include <machine/board.h>
|
/freebsd-10.1-release/sys/dev/ida/ |
H A D | ida_eisa.c | 224 for (i = 0; board_id[i].board; i++) 225 if (board_id[i].board == id) 233 struct ida_board *board; local 237 board = ida_eisa_match(eisa_get_id(dev)); 238 if (board == NULL) 240 device_set_desc(dev, board->desc); 275 struct ida_board *board; local 282 board = ida_eisa_match(eisa_get_id(dev)); 283 ida->cmd = *board->accessor; 284 ida->flags = board [all...] |
H A D | ida_pci.c | 214 for (i = 0; board_id[i].board; i++) 215 if (board_id[i].board == sub_id) 224 struct ida_board *board = ida_pci_match(dev); local 226 if (board != NULL) { 227 device_set_desc(dev, board->desc); 236 struct ida_board *board = ida_pci_match(dev); local 243 ida->cmd = *board->accessor; 244 ida->flags = board->flags;
|
/freebsd-10.1-release/sys/dev/ctau/ |
H A D | ctddk.c | 92 /* init board structure */ 124 /* Load firmware and set up board */ 147 ct_setup_g703 (c->board); 184 * Configure Tau/E1 board. 208 * Config Tau/G.703 board 234 c->board->opt.clk1 = clk; 236 c->board->opt.clk0 = clk; 238 ct_setup_e1 (c->board); 241 ct_setup_g703 (c->board); 249 return c->num ? c->board [all...] |
H A D | ctau.c | 270 * Check if the Tau board is present at the given base port. 271 * Read board status register 1 and check identification bits 355 /* Initialize board structure. */ 363 /* Get the board type. */ 390 * Initialize the board structure. 421 /* Get the board type. */ 469 c->board = b; 539 ct_board_t *b = c->board; 582 c->board->opt.bcr2 &= c->num ? 600 c->board [all...] |
/freebsd-10.1-release/sys/mips/rmi/ |
H A D | board.c | 42 #include <mips/rmi/board.h> 70 xlr_chip_specific_overrides(struct xlr_board_info* board) argument 76 blk0 = &board->gmac_block[0]; 77 blk1 = &board->gmac_block[1]; 78 blk2 = &board->gmac_block[2]; 152 xlr_board_specific_overrides(struct xlr_board_info* board) argument 156 blk1 = &board->gmac_block[1]; 157 blk2 = &board->gmac_block[2]; 206 xls_chip_specific_overrides(struct xlr_board_info* board) argument 211 blk0 = &board 235 xls_board_specific_overrides(struct xlr_board_info* board) argument [all...] |
/freebsd-10.1-release/sys/dev/cx/ |
H A D | cxddk.c | 153 if (c->board->dma) { 162 if (c->board->dma) 829 if (c->board->type == B_SIGMA_XXX) { 832 if ((c->board->if0type != 0) == (iftype != 0)) 834 c->board->if0type = iftype; 835 c->board->bcr0 &= ~BCR0_UMASK; 836 if (c->board->if0type && 838 c->board->bcr0 |= BCR0_UI_RS449; 839 outb (BCR0(c->board->port), c->board [all...] |
H A D | csigma.c | 143 * Check if the Sigma-XXX board is present at the given base port. 149 /* Read and check the board revision code. */ 186 * Check if the Sigma-800 board is present at the given base port. 187 * Read board status register 1 and check identification bits 214 * Check if the Sigma-2x board is present at the given base port. 220 /* Read and check the board revision code. */ 234 * Check if the Cronyx-Sigma board is present at the given base port. 252 /* chained board attached */ 254 /* invalid chained board? */ 257 /* invalid chained board fla [all...] |
/freebsd-10.1-release/sys/dev/ath/ath_hal/ |
H A D | ah_soc.h | 26 * This is board-specific data that is stored in a "known" 34 uint32_t magic; /* board data is valid */ 39 char boardName[64]; /* Name of board */ 86 const struct ar531x_boarddata *board; /* board config data */ member in struct:ar531x_config
|
/freebsd-10.1-release/sys/mips/cavium/octe/ |
H A D | wrapper-cvmx-includes.h | 46 #include <contrib/octeon-sdk/cvmx-helper-board.h>
|
/freebsd-10.1-release/sys/mips/nlm/ |
H A D | uart_cpu_xlp.c | 64 #include <mips/nlm/board.h>
|
/freebsd-10.1-release/sys/sparc64/fhc/ |
H A D | fhc.c | 166 uint32_t board; local 195 board = bus_read_4(sc->sc_memres[FHC_INTERNAL], FHC_BSR); 196 board = ((board >> 16) & 0x1) | ((board >> 12) & 0xe); 198 if (OF_getprop(node, "board#", &board, sizeof(board)) == -1) { 199 device_printf(dev, "cannot get board number\n"); 205 device_printf(dev, "board [all...] |
/freebsd-10.1-release/sys/dev/ce/ |
H A D | ceddk.c | 226 b = c->board; 298 CE_DDK_DEBUG (c->board, c, ("Another transmit error: %x\n", 346 if (!TAU32_SubmitRequest (c->board->ddk.pControllerObject, req)) { 347 CE_DDK_DEBUG (c->board, c, ("Can't submit packet for " 531 ce_board_t *b = c->board; 620 ce_board_t *b = c->board; 737 unsigned int e1status = c->board->ddk.InterfacesInfo[c->dir].Status; 756 ce_board_t *b = c->board; 938 ce_board_t *b = c->board; 987 ce_board_t *b = c->board; [all...] |