/u-boot/board/mediatek/mt8518/ |
H A D | mt8518_ap1.c | 20 debug("gd->fdt_blob is %p\n", gd->fdt_blob);
|
/u-boot/board/nvidia/p2371-0000/ |
H A D | p2371-0000.c | 21 debug("%s: Set LDO2 for VDDIO_SDMMC_AP power to 3.3V\n", __func__);
|
/u-boot/board/nvidia/cardhu/ |
H A D | cardhu.c | 51 debug("%s: Cannot find PMIC I2C chip\n", __func__); 99 debug("failed to find PMU bus\n"); 109 debug("failed to set VDD supply\n"); 126 debug("failed to set AVDD supply\n");
|
/u-boot/common/spl/ |
H A D | spl_xip.c | 22 debug("spl: payload xipImage, load addr: 0x%lx\n",
|
H A D | spl_ram.c | 25 debug("%s: sector %lx, count %lx, buf %lx\n", 72 debug("Found FIT\n"); 79 debug("Legacy image\n"); 85 debug("u_boot_pos = %lx\n", u_boot_pos);
|
/u-boot/drivers/mmc/ |
H A D | mmc_boot.c | 37 debug("mmc_boot_partition_size_change: Error1 = %d\n", err); 48 debug("mmc_boot_partition_size_change: Error2 = %d\n", err); 61 debug("mmc_boot_partition_size_change: Error3 = %d\n", err); 73 debug("mmc_boot_partition_size_change: Error4 = %d\n", err);
|
/u-boot/arch/powerpc/lib/ |
H A D | stack.c | 44 debug("Reserving MP boot page to %08lx\n", gd->relocaddr);
|
/u-boot/arch/arm/cpu/armv7/ |
H A D | exception_level.c | 31 debug("Reached non-secure mode\n");
|
/u-boot/arch/arm/mach-aspeed/ast2600/ |
H A D | board_common.c | 38 debug("cannot get DRAM driver\n"); 44 debug("cannot get DRAM information\n"); 79 debug("%s: cannot find SCU device, rc=%d\n", __func__, rc); 85 debug("%s: cannot get SCU address pointer\n", __func__);
|
/u-boot/arch/arm/mach-tegra/tegra30/ |
H A D | cpu.c | 26 debug("enable_cpu_power_rail entry\n"); 43 debug("t30_init_clocks entry\n"); 84 debug("set_cpu_running entry, run = %d\n", run); 90 debug("start_cpu entry, reset_vector = %x\n", reset_vector);
|
/u-boot/board/xilinx/versal/ |
H A D | cmds.c | 25 debug("pdi_load: incorrect parameters passed\n"); 31 debug("pdi_load: zero pdi_data address\n"); 37 debug("pdi_load: zero size\n"); 44 debug("Pdi addr:0x%lx aligned to 0x%lx\n",
|
/u-boot/drivers/video/ |
H A D | simplefb.c | 27 debug("%s: Failed to decode memory region\n", __func__); 31 debug("%s: base=%llx, size=%llu\n", __func__, base, size); 42 debug("%s: Query resolution...\n", __func__); 56 debug("%s: %dx%d@%s\n", __func__, uc_priv->xsize, uc_priv->ysize, format);
|
/u-boot/drivers/watchdog/ |
H A D | ftwdt010_wdt.c | 33 debug("Reset WDT..\n"); 57 debug("Activating WDT %llu ms\n", timeout_ms); 82 debug("Deactivating WDT..\n"); 99 debug("Expiring WDT..\n");
|
/u-boot/arch/mips/mach-octeon/ |
H A D | octeon_fdt.c | 188 debug("In %s: Patching FDT header at 0x%p with key \"%s\"\n", __func__, fdt, fdt_key); 209 debug("fdt found trim name %s, comparing key \"%s\"(%d) with \"%s\"(%d)\n", 217 debug("fdt key number \"%s\" matches\n", val); 219 debug("Key \"%s\" does not match \"%s\"\n", val, fdt_key); 224 debug("Trimming alias \"%s\"\n", val); 242 debug("fdt trimming matching key %s\n", fdt_key); 250 debug("%s: Starting pass 2 for key %s\n", __func__, fdt_key); 261 debug("Searching stringlist %s for %s\n", val, fdt_key); 268 debug("Found key %s at offset 0x%x\n", fdt_key, offset); 273 debug(" nam [all...] |
/u-boot/drivers/sound/ |
H A D | wm8994.c | 83 debug("Write Addr : 0x%04X, Data : 0x%04X\n", reg, data); 105 debug("%s: Error while reading register %#04x\n", 176 debug("%s: Invalid audio interface selection\n", __func__); 187 debug("%s: Invalid i2s master selection\n", __func__); 206 debug("%s: Invalid i2s format selection\n", __func__); 221 debug("%s: Invalid i2s frame inverse selection\n", 243 debug("%s: Invalid i2s clock polarity selection\n", 249 debug("%s: Invalid i2s format selection\n", __func__); 261 debug("%s: codec register access error\n", __func__); 340 debug(" [all...] |
/u-boot/arch/arc/lib/ |
H A D | relocate.c | 46 debug("Section .rela.dyn is located at %08x-%08x\n", 76 debug("Patching value @ %08x (relocated to %08x)%s\n", 95 /* TODO: Use panic() instead of debug() 117 debug("Relocation target %08x points outside of image\n",
|
/u-boot/lib/ |
H A D | initcall.c | 64 debug("initcall: event %d/%s\n", type, 67 debug("initcall: %p (relocated to %p)\n", 70 debug("initcall: %p\n", (char *)func - reloc_ofs);
|
/u-boot/drivers/axi/ |
H A D | axi-emul-uclass.c | 34 debug("%s: Unknown AXI transfer size '%d'", bus->name, size); 49 debug("%s: Could not read 'reg' property of %s\n", 61 debug("%s: Could not activate %s\n",
|
/u-boot/drivers/dfu/ |
H A D | dfu_alt.c | 33 debug("%s: name: %s addr: 0x%p len: %d device: %s:%s\n", __func__, 54 debug("%s: image name: %s strlen: %zd\n", __func__, sb, strlen(sb)); 99 debug("%s: alt: %d addr: 0x%p len: %d device: %s:%s\n", __func__,
|
/u-boot/arch/arm/mach-socfpga/ |
H A D | spl_agilex.c | 59 debug("Clock init failed: %d\n", ret); 70 debug("CCU init failed: %d\n", ret); 77 debug("DRAM init failed: %d\n", ret);
|
/u-boot/arch/arm/mach-omap2/ |
H A D | sec-common.c | 155 debug("%s: load_addr = %x, size = %x, sig_addr = %x\n", __func__, 222 debug("%s: regionNum = %x, startAddr = %x, size = %x", __func__, 232 debug("Return Value = %x\n", result); 264 debug("Return Value = %x\n", result); 288 debug("Return Value = %x\n", result); 333 debug("tee_info.tee_sec_mem_start= %08X\n", tee_info.tee_sec_mem_start); 334 debug("tee_info.tee_sec_mem_size = %08X\n", tee_info.tee_sec_mem_size); 335 debug("tee_info.tee_jump_addr = %08X\n", tee_info.tee_jump_addr); 336 debug("tee_info.tee_cert_start = %08X\n", tee_info.tee_cert_start); 337 debug("tee_inf [all...] |
/u-boot/arch/arm/mach-rockchip/ |
H A D | boot_mode.c | 95 debug("%s: boot mode 0x%08x\n", __func__, boot_mode); 102 debug("%s: enter fastboot!\n", __func__); 106 debug("%s: enter UMS!\n", __func__);
|
/u-boot/drivers/net/ |
H A D | bcm-sf2-eth.c | 54 debug("Connecting PHY 0...\n"); 61 debug("No PHY found for port 0\n"); 81 debug("%s enter\n", __func__); 86 debug("ERROR - Tx failed\n"); 92 debug("."); 101 debug("%s exit rc(0x%x)\n", __func__, rc); 119 debug("\nNO More Rx\n"); 126 debug("recieved\n"); 157 debug("Enabling BCM SF2 Ethernet.\n"); 181 debug("PH [all...] |
/u-boot/drivers/power/pmic/ |
H A D | max77686.c | 57 debug("%s: %s regulators subnode not found!\n", __func__, 62 debug("%s: '%s' - found regulators subnode\n", __func__, dev->name); 66 debug("%s: %s - no child found\n", __func__, dev->name);
|
H A D | s2mps11.c | 58 debug("%s: %s regulators subnode not found!\n", __func__, 63 debug("%s: '%s' - found regulators subnode\n", __func__, dev->name); 67 debug("%s: %s - no child found\n", __func__, dev->name);
|