/* wjm 17-aug-1995: add a hook for special treatment of VMS_LOCALUNIT */ /* * refclock_local - local pseudo-clock driver */ #ifdef HAVE_CONFIG_H #include #endif #ifdef REFCLOCK #include "ntpd.h" #include "ntp_refclock.h" #include "ntp_stdlib.h" #include #include #ifdef KERNEL_PLL #include "ntp_syscall.h" #endif /* * This is a hack to allow a machine to use its own system clock as a * reference clock, i.e., to free-run using no outside clock discipline * source. This is useful if you want to use NTP in an isolated * environment with no radio clock or NIST modem available. Pick a * machine that you figure has a good clock oscillator and configure it * with this driver. Set the clock using the best means available, like * eyeball-and-wristwatch. Then, point all the other machines at this * one or use broadcast (not multicast) mode to distribute time. * * Another application for this driver is if you want to use a * particular server's clock as the clock of last resort when all other * normal synchronization sources have gone away. This is especially * useful if that server has an ovenized oscillator. For this you would * configure this driver at a higher stratum (say 5) to prevent the * server's stratum from falling below that. * * A third application for this driver is when an external discipline * source is available, such as the NIST "lockclock" program, which * synchronizes the local clock via a telephone modem and the NIST * Automated Computer Time Service (ACTS), or the Digital Time * Synchronization Service (DTSS), which runs on DCE machines. In this * case the stratum should be set at zero, indicating a bona fide * stratum-1 source. Exercise some caution with this, since there is no * easy way to telegraph via NTP that something might be wrong in the * discipline source itself. In the case of DTSS, the local clock can * have a rather large jitter, depending on the interval between * corrections and the intrinsic frequency error of the clock * oscillator. In extreme cases, this can cause clients to exceed the * 128-ms slew window and drop off the NTP subnet. * * THis driver includes provisions to telegraph synchronization state * and related variables by means of kernel variables with specially * modified kernels. This is done using the ntp_adjtime() syscall. * In the cases where another protocol or device synchronizes the local * host, the data given to the kernel can be slurped up by this driver * and distributed to clients by ordinary NTP messaging. * * In the default mode the behavior of the clock selection algorithm is * modified when this driver is in use. The algorithm is designed so * that this driver will never be selected unless no other discipline * source is available. This can be overriden with the prefer keyword of * the server configuration command, in which case only this driver will * be selected for synchronization and all other discipline sources will * be ignored. This behavior is intended for use when an external * discipline source controls the system clock. * * Fudge Factors * * The stratum for this driver set at 5 by default, but it can be changed * by the fudge command and/or the ntpdc utility. The reference ID is * "LCL" by default, but can be changed using the same mechanism. *NEVER* * configure this driver to operate at a stratum which might possibly * disrupt a client with access to a bona fide primary server, unless the * local clock oscillator is reliably disciplined by another source. * *NEVER NEVER* configure a server which might devolve to an undisciplined * local clock to use multicast mode. Always remember that an improperly * configured local clock driver let loose in the Internet can cause * very serious disruption. This is why most of us who care about good * time use cryptographic authentication. * * This driver provides a mechanism to trim the local clock in both time * and frequency, as well as a way to manipulate the leap bits. The * fudge time1 parameter adjusts the time, in seconds, and the fudge * time2 parameter adjusts the frequency, in ppm. The fudge time1 parameter * is additive; that is, it adds an increment to the current time. The * fudge time2 parameter directly sets the frequency. */ /* * Local interface definitions */ #define PRECISION (-7) /* about 10 ms precision */ #define REFID "LCL\0" /* reference ID */ #define DESCRIPTION "Undisciplined local clock" /* WRU */ #define STRATUM 5 /* default stratum */ #define DISPERSION .01 /* default dispersion (10 ms) */ /* * Imported from the timer module */ extern u_long current_time; /* * Imported from ntp_proto */ extern s_char sys_precision; #ifdef KERNEL_PLL /* * Imported from ntp_loopfilter */ extern int pll_control; /* kernel pll control */ extern int kern_enable; /* kernel pll enabled */ extern int ext_enable; /* external clock enable */ #endif /* KERNEL_PLL */ /* * Function prototypes */ static int local_start P((int, struct peer *)); static void local_poll P((int, struct peer *)); /* * Local variables */ static u_long poll_time; /* last time polled */ /* * Transfer vector */ struct refclock refclock_local = { local_start, /* start up driver */ noentry, /* shut down driver (not used) */ local_poll, /* transmit poll message */ noentry, /* not used (old lcl_control) */ noentry, /* initialize driver (not used) */ noentry, /* not used (old lcl_buginfo) */ NOFLAGS /* not used */ }; /* * local_start - start up the clock */ static int local_start( int unit, struct peer *peer ) { struct refclockproc *pp; pp = peer->procptr; /* * Initialize miscellaneous variables */ peer->precision = sys_precision; peer->stratum = STRATUM; pp->clockdesc = DESCRIPTION; memcpy((char *)&pp->refid, REFID, 4); #if defined(VMS) && defined(VMS_LOCALUNIT) /* provide a non-standard REFID */ if(unit == VMS_LOCALUNIT) memcpy((char *)&pp->refid,"LCLv",4); #endif /* VMS && VMS_LOCALUNIT */ poll_time = current_time; return (1); } /* * local_poll - called by the transmit procedure */ static void local_poll( int unit, struct peer *peer ) { struct refclockproc *pp; #if defined(KERNEL_PLL) && defined(STA_CLK) struct timex ntv; int retval; #endif /* KERNEL_PLL STA_CLK */ #if defined(VMS) && defined(VMS_LOCALUNIT) if(unit == VMS_LOCALUNIT) { extern void vms_local_poll(struct peer *); vms_local_poll(peer); return; } #endif /* VMS && VMS_LOCALUNIT */ pp = peer->procptr; pp->polls++; /* * Ramble through the usual filtering and grooming code, which * is essentially a no-op and included mostly for pretty * billboards. We allow a one-time time adjustment using fudge * time1 (s) and a continuous frequency adjustment using fudge * time 2 (ppm). */ get_systime(&pp->lastrec); pp->fudgetime1 += pp->fudgetime2 * 1e-6 * (current_time - poll_time); poll_time = current_time; refclock_process_offset(pp, pp->lastrec, pp->lastrec, pp->fudgetime1); pp->leap = LEAP_NOWARNING; pp->disp = DISPERSION; pp->jitter = 0; #if defined(KERNEL_PLL) && defined(STA_CLK) /* * If the kernel pll code is up and running, somebody else * may come diddle the clock. If so, they better use ntp_adjtime(), * and set the STA_CLK bit in the status word. In this case, the * performance information is read from the kernel and becomes the * variables presented to the clock mitigation process. */ if (pll_control && kern_enable && (peer->flags & FLAG_PREFER)) { memset((char *)&ntv, 0, sizeof ntv); retval = ntp_adjtime(&ntv); if (ntv.status & STA_CLK) { ext_enable = 1; switch(retval) { case TIME_OK: pp->leap = LEAP_NOWARNING; break; case TIME_INS: pp->leap = LEAP_ADDSECOND; break; case TIME_DEL: pp->leap = LEAP_DELSECOND; break; case TIME_ERROR: pp->leap = LEAP_NOTINSYNC; } pp->disp = ntv.maxerror / 1e6; pp->jitter = SQUARE(ntv.esterror / 1e6); } } else { ext_enable = 0; } #endif /* KERNEL_PLL STA_CLK */ refclock_receive(peer); pp->fudgetime1 = 0; } #else int refclock_local_bs; #endif /* REFCLOCK */