Lines Matching refs:This
27 * This file is through cpp before being used as
153 ! This code is run at TL > 0, being exec'd via a cross trap.
159 ! This ASI must be specified explicitly (via casxa), rather
160 ! than using casx. This is because of the fact that the
163 ! on bad trap following repetitive dtlb misses. This behavior
206 ! will fail the idle check. This could be made more lenient
367 ! NOTE: This store will allocate in the E$. It is
416 ! Perform HW register reprogramming. This is the "rename" step for
429 ! does not implement read bypass. This is true of Cheetah,
440 ! This section will be empty if this processor is not a Panther.
447 ! an error code if a MC fails to go idle. This section will
458 ! This list is typically used for reprogramming the Memory
465 ! This list typically contains address/value pairs for
563 ! 32KB on Jaguar/Panther boards) reserved for DR. This area is
568 ! This routine begins by mapping the appropriate SRAM page,
583 ! as a semaphore. This avoids unwanted bus traffic during the critical
628 ! boundary. This will define the start of the data area.
706 ! This will demote the state of the line in E$ to I.
708 ! victimized before returning to the OS. This is vital because