Lines Matching refs:sensor
40 below. In the most general case, to support a sensor there are three steps
67 /* Return a pointer the sensor struct attached to the camera */
74 /* Attach a probed sensor to the camera. */
77 const struct sn9c102_sensor* sensor);
80 /* The "try" I2C I/O versions are used when probing the sensor */
88 These must be used if and only if the sensor doesn't implement the standard
93 data1, and places the n bytes read from the sensor register table in the
99 const struct sn9c102_sensor* sensor, u8 n,
103 const struct sn9c102_sensor* sensor,
106 /* To be used after the sensor struct has been attached to the camera struct */
110 /* I/O on registers in the bridge. Could be used by the sensor methods too */
145 char name[32], /* sensor name */
154 These sensor capabilities must be provided if the SN9C1XX controller
155 needs to communicate through the sensor serial interface by using
162 This identifier must be provided if the image sensor implements
175 This function will be called after the sensor has been attached.
176 It should be used to initialize the sensor only, but may also
185 sensor according to the default configuration structures below.
208 Think the image sensor as a grid of R,G,B monochromatic pixels
211 use this coordinate system from now on. It is assumed the sensor
227 If necessary, the sensor chip must be initialized during init() to
228 set the bounds of the active sensor window; however, by default, it
269 of reg 0x17 during the initialization of the image sensor.
271 rid of any blank pixels, so that the output of the sensor