Lines Matching refs:dbg
279 dbg ("%s - wanted to write %d, but only wrote %d",
309 dbg ("%s - wanted to write %d, but only wrote %d",
334 dbg ("%s - port %d, mask %x", __FUNCTION__, port_number, mask);
359 dbg ("%s - @ %x for %d", __FUNCTION__, start_address, length);
371 dbg ("%s - @ %x for %d", __FUNCTION__,
383 dbg ("%s - ERROR %x", __FUNCTION__, status);
424 dbg ("%s - ERROR %x", __FUNCTION__, status);
429 dbg ("%s - start_address = %x, length = %d", __FUNCTION__, start_address, length);
462 dbg ("%s - start_sddr = %x, length = %d", __FUNCTION__, start_address, length);
484 dbg ("%s - BytesInFirstPage Addr = %x, length = %d", __FUNCTION__, start_address, write_length);
496 dbg ("%s - ERROR %d", __FUNCTION__, status);
511 dbg ("%s - Page Write Addr = %x, length = %d", __FUNCTION__, start_address, write_length);
569 dbg ("%s - XByteCount 0x%X", __FUNCTION__, oedb->XByteCount);
579 dbg ("%s - LSR = 0x%X", __FUNCTION__, *lsr);
590 dbg ("%s - return %d", __FUNCTION__, bytes_left );
654 dbg ("%s - Number of Interfaces = %d", __FUNCTION__, dev->config->desc.bNumInterfaces);
655 dbg ("%s - MAX Power = %d", __FUNCTION__, dev->config->desc.bMaxPower*2);
741 dbg ("%s - Mismatch %x - %x", __FUNCTION__, rom_desc->CheckSum, cs);
791 dbg ("%s - structure too big, erroring out.", __FUNCTION__);
795 dbg ("%s Type = 0x%x", __FUNCTION__, rom_desc->Type);
841 dbg ("%s - Edge Descriptor not found in I2C", __FUNCTION__);
857 dbg ( "%s - IonConfig 0x%x", __FUNCTION__, desc->IonConfig );
858 dbg ( "%s - Version %d", __FUNCTION__, desc->Version );
859 dbg ( "%s - Cpu/Board 0x%x", __FUNCTION__, desc->CpuRev_BoardRev );
860 dbg ( "%s - NumPorts %d", __FUNCTION__, desc->NumPorts );
861 dbg ( "%s - NumVirtualPorts %d", __FUNCTION__, desc->NumVirtualPorts );
862 dbg ( "%s - TotalPorts %d", __FUNCTION__, desc->TotalPorts );
945 dbg ("%s - read 2 status error = %d", __FUNCTION__, status);
947 dbg ("%s - read 2 data = 0x%x", __FUNCTION__, data);
949 dbg ("%s - ROM_TYPE_II", __FUNCTION__);
962 dbg ("%s - read 3 status error = %d", __FUNCTION__, status);
964 dbg ("%s - read 2 data = 0x%x", __FUNCTION__, data);
966 dbg ("%s - ROM_TYPE_III", __FUNCTION__);
971 dbg ("%s - Unknown", __FUNCTION__);
1075 dbg ("%s - <<<<<<<<<<<<<<<RUNNING IN DOWNLOAD MODE>>>>>>>>>>", __FUNCTION__);
1079 dbg ("%s - <<<<<<<<<<<<<<<DOWNLOAD MODE -- BAD I2C >>>>>>>>>>",
1100 dbg ( "%s - Wrong CPU Rev %d (Must be 2)", __FUNCTION__,
1118 dbg ("%s - Found Type FIRMWARE (Type 2) record", __FUNCTION__);
1147 dbg ("%s - >>>Firmware Versions Device %d.%d Driver %d.%d",
1156 dbg ("%s - Update I2C Download from %d.%d to %d.%d",
1206 dbg ("%s - HARDWARE RESET", __FUNCTION__);
1216 dbg ( "%s - HARDWARE RESET return %d", __FUNCTION__, status);
1249 dbg ("%s - Found Type BLANK FIRMWARE (Type F2) record", __FUNCTION__);
1287 dbg ("%s - can't read header back", __FUNCTION__);
1295 dbg ("%s - write download record failed", __FUNCTION__);
1306 dbg ("%s - Start firmware update", __FUNCTION__);
1316 dbg ("%s - Update complete 0x%x", __FUNCTION__, status);
1334 dbg ("%s - <<<<<<<<<<<<<<<RUNNING IN BOOT MODE>>>>>>>>>>>>>>>",
1343 dbg ("%s - VID = 0x%x", __FUNCTION__,
1357 dbg ("%s - TIStayInBootMode", __FUNCTION__);
1385 dbg ("%s - Wrong CPU Rev %d (Must be 2)", __FUNCTION__,
1429 dbg ("%s - Downloading operational code image (TI UMP)", __FUNCTION__);
1435 dbg ("%s - Error downloading operational code image", __FUNCTION__);
1442 dbg ("%s - Download successful -- Device rebooting...", __FUNCTION__);
1450 dbg ("%s - <<<<<<<<<<<<<<<STAYING IN BOOT MODE>>>>>>>>>>>>", __FUNCTION__);
1461 dbg ("%s", __FUNCTION__);
1476 dbg ("%s", __FUNCTION__);
1491 dbg ("%s", __FUNCTION__);
1506 dbg ("%s", __FUNCTION__);
1521 dbg ("%s", __FUNCTION__);
1535 dbg ("%s", __FUNCTION__);
1549 dbg ("%s", __FUNCTION__);
1563 dbg ("%s", __FUNCTION__);
1577 dbg ("%s - %x", __FUNCTION__, mcr);
1631 dbg ("%s - %02x", __FUNCTION__, msr);
1670 dbg ("%s - %02x", __FUNCTION__, new_lsr);
1712 dbg("%s", __FUNCTION__);
1722 dbg("%s - urb shutting down with status: %d", __FUNCTION__, urb->status);
1730 dbg ("%s - no data in urb", __FUNCTION__);
1737 dbg ("%s - expecting packet of size 2, got %d", __FUNCTION__, length);
1743 dbg ("%s - port_number %d, function %d, info 0x%x",
1748 dbg ("%s - edge_port not found", __FUNCTION__);
1756 dbg ("%s - LSR Event Port %u LSR Status = %02x",
1761 dbg ("%s - ===== Port %d LSR Status = %02x ======",
1770 dbg ("%s - ===== Port %u MSR Status = %02x ======\n",
1797 dbg("%s", __FUNCTION__);
1807 dbg("%s - urb shutting down with status: %d", __FUNCTION__, urb->status);
1826 dbg ("%s ===== Port %u LSR Status = %02x, Data = %02x ======",
1839 dbg ("%s - close is pending, dropping data on the floor.", __FUNCTION__);
1886 dbg ("%s - port %d", __FUNCTION__, port->number);
1898 dbg("%s - urb shutting down with status: %d", __FUNCTION__, urb->status);
1920 dbg("%s - port %d", __FUNCTION__, port->number);
1943 dbg ("%s - port_number = %d, uart_base = %04x, dma_address = %04x",
1974 dbg ("%s - Sending UMPC_OPEN_PORT", __FUNCTION__);
2019 dbg ("ShadowMSR 0x%X", edge_port->shadow_msr);
2023 dbg ("ShadowMCR 0x%X", edge_port->shadow_mcr);
2068 dbg("%s - exited", __FUNCTION__);
2087 dbg("%s - port %d", __FUNCTION__, port->number);
2107 dbg("%s - send umpc_close_port", __FUNCTION__);
2125 dbg("%s - exited", __FUNCTION__);
2133 dbg("%s - port %d", __FUNCTION__, port->number);
2136 dbg("%s - write request of 0 bytes", __FUNCTION__);
2162 dbg("%s - port %d", __FUNCTION__, port->number);
2218 dbg("%s - port %d", __FUNCTION__, port->number);
2229 dbg("%s - returns %d", __FUNCTION__, room);
2239 dbg("%s - port %d", __FUNCTION__, port->number);
2250 dbg ("%s - returns %d", __FUNCTION__, chars);
2260 dbg("%s - port %d", __FUNCTION__, port->number);
2267 dbg ("%s - no tty available", __FUNCTION__);
2293 dbg("%s - port %d", __FUNCTION__, port->number);
2300 dbg ("%s - no tty available", __FUNCTION__);
2368 dbg("%s - port %d", __FUNCTION__, edge_port->port->number);
2373 dbg("%s - no tty structures", __FUNCTION__);
2395 dbg ("%s - data bits = 5", __FUNCTION__);
2399 dbg ("%s - data bits = 6", __FUNCTION__);
2403 dbg ("%s - data bits = 7", __FUNCTION__);
2408 dbg ("%s - data bits = 8", __FUNCTION__);
2416 dbg("%s - parity = odd", __FUNCTION__);
2420 dbg("%s - parity = even", __FUNCTION__);
2424 dbg("%s - parity = none", __FUNCTION__);
2429 dbg("%s - stop bits = 2", __FUNCTION__);
2432 dbg("%s - stop bits = 1", __FUNCTION__);
2439 dbg("%s - RTS/CTS is enabled", __FUNCTION__);
2441 dbg("%s - RTS/CTS is disabled", __FUNCTION__);
2454 dbg ("%s - INBOUND XON/XOFF is enabled, XON = %2x, XOFF = %2x",
2457 dbg ("%s - INBOUND XON/XOFF is disabled", __FUNCTION__);
2463 dbg ("%s - OUTBOUND XON/XOFF is enabled, XON = %2x, XOFF = %2x",
2466 dbg ("%s - OUTBOUND XON/XOFF is disabled", __FUNCTION__);
2479 dbg ("%s - baud rate = %d, wBaudRate = %d", __FUNCTION__, baud, config->wBaudRate);
2481 dbg ("wBaudRate: %d", (int)(461550L / config->wBaudRate));
2482 dbg ("wFlags: 0x%x", config->wFlags);
2483 dbg ("bDataBits: %d", config->bDataBits);
2484 dbg ("bParity: %d", config->bParity);
2485 dbg ("bStopBits: %d", config->bStopBits);
2486 dbg ("cXon: %d", config->cXon);
2487 dbg ("cXoff: %d", config->cXoff);
2488 dbg ("bUartMode: %d", config->bUartMode);
2501 dbg ("%s - error %d when trying to write config to device",
2517 dbg ("%s - no tty or termios", __FUNCTION__);
2526 dbg ("%s - nothing to change", __FUNCTION__);
2531 dbg("%s - clfag %08x iflag %08x", __FUNCTION__,
2534 dbg("%s - old clfag %08x old iflag %08x", __FUNCTION__,
2538 dbg("%s - port %d", __FUNCTION__, port->number);
2554 dbg("%s - port %d", __FUNCTION__, port->number);
2585 dbg("%s - port %d", __FUNCTION__, port->number);
2597 dbg("%s -- %x", __FUNCTION__, result);
2636 dbg("%s - port %d, cmd = 0x%x", __FUNCTION__, port->number, cmd);
2640 dbg("%s - (%d) TIOCINQ", __FUNCTION__, port->number);
2645 dbg("%s - (%d) TIOCSERGETLSR", __FUNCTION__, port->number);
2650 dbg("%s - (%d) TIOCGSERIAL", __FUNCTION__, port->number);
2655 dbg("%s - (%d) TIOCSSERIAL", __FUNCTION__, port->number);
2659 dbg("%s - (%d) TIOCMIWAIT", __FUNCTION__, port->number);
2682 dbg ("%s - (%d) TIOCGICOUNT RX=%d, TX=%d", __FUNCTION__,
2697 dbg ("%s - state = %d", __FUNCTION__, break_state);
2708 dbg ("%s - error %d sending break set/clear command.",
2778 dbg ("%s", __FUNCTION__);