Lines Matching refs:power
222 Retrieve the current AR6000 device Tx power levels
275 Support a non-standard power management scheme for an
290 Set guidelines on trade-off between power utilization
292 Configure power parameters
294 Set the two AR6000 power save timers
311 Specify the AR6000 device Tx power levels
660 Specifies whether the voice power save mechanism
663 = 0 Disable voice power save for traffic class
664 = 1 Enable APSD voice power save for traffic class
665 = 2 Enable voice power save for all traffic classes
1141 The host uses this command to retrieve the current Tx power level
1150 UINT16 dbM The current Tx power level specified in dbM
1546 impact on power savings. To some degree, a longer interval reduces power
1991 Used to support a non-standard power management scheme for an ad hoc wireless
1992 network consisting of up to eight stations (STAs) that support this form of power
2005 The non-standard power saving scheme is
2007 power saving) is obtained.
2010 Ad hoc power saving scheme is enabled (but
2023 between power use and throughput. The value
2044 trade off between throughput and power.
2279 desired trade-off between power utilization and performance.
2281 In normal power mode, the device enters a sleep state if they have nothing to do,
2282 which conserves power but may cost performance as it can take up to 2 ms to
2286 is spent waking up, resulting in higher power consumption and better
2298 power without sacrificing performance
2301 the expense of power
2316 For a PM-disabled ad hoc network, the power mode should remain in
2320 MAX_PERF_POWER set, but either way it must follow the power save ad hoc
2321 protocol. The host can change power modes in the CONNECTED state.
2333 The host uses this command to configure power parameters
2390 Set the two AR6000 power save timers (PS-POLL timer and APSD trigger timer) and
2810 The host uses this command to specify the Tx power level of the AR6000. Cannot be
2811 used to exceed the power limit permitted by the regulatory domain. The maximum
2812 output power is limited in the chip to 31.5 dBm; the range is 0 � 31.5 dbm.
2815 wmiconfig --power <dbM>
2819 The desired Tx power specified in dbM.
3542 A non-power save disabled node has joined
3745 power on or reset. It also indicates the MAC address of the device.