Lines Matching refs:state
86 In this state, the AR6000 device is not connected to a wireless
87 network. The device is in this state after reset when it sends the
91 transition to the DISCONNECTED state with a �DISCONNECT�
95 In this state, the AR6000 device is connected to wireless networks.
96 The device enters this state after successfully processing a
98 network. The device signals a transition to the CONNECTED state
150 state. The host is required to wait for an event signaling a state transition
152 the device to be in the CONNECTED state, then the host is required to wait
155 The device ignores any commands inappropriate for its current state. If the
635 Issuing the command in disconnected state, reassociation or ADDTS is not
781 This command can only be issued when the device is in the CONNECTED state. If
782 the device receives the command while in DISCONNECTED state, it replies with a
980 for use in production. It is only valid when the device is in the CONNECTED state
1511 This command can only be issued in the DISCONNECTED state
1848 connection. This command should only be issued in the DISCONNECTED state.
1866 event to the host. The state is maintained until a shutdown or host sets different
1885 This command can only be issued while in a DISCONNECTED state
2281 In normal power mode, the device enters a sleep state if they have nothing to do,
2283 resume operation after leaving sleep state.
2285 In maximum performance mode, the device never enters sleep state, thus no time
2313 This command should only be issued in the DISCONNECTED state for the
2321 protocol. The host can change power modes in the CONNECTED state.
2343 to SLEEP state
2696 enters the DISCONNECTED state after losing connectivity with an AP or when a
3381 Illegal state
3442 command or as a result of a transition from a connected state to disconnected state.