Lines Matching refs:is
32 A: You are right, it does not work. The command written above is split to two commands.
57 this particular route is {\em abnormal}:
62 Note keyword \verb|onlink|, it is the magic key that orders kernel
74 that between \verb|route add| and \verb|route del| host 193.233.7.65 is
90 packets to another endpoint is not hidden. If you dislike this, or if you
122 but address of peering host, which is directly reachable
133 kinds and gateway is required to be directly reachable via this tunnel,
162 The \verb|<NAME>| is an arbitrary string. Particularly,
187 This restriction is relaxed for keyed GRE tunnels.}
197 After tunnel device is created you should configure it as you did
204 growing number of tunneled fragments is very real.
213 The only way to make it is to create special routes with gateway
218 It is important to use option \verb|onlink|, otherwise
220 reachable over device \verb|tunl0|. With IPv6 the situation is much simpler:
223 Internet is {\em really reachable} via \verb|sit0|! Excellent, the command
236 \verb|N| is number in the range 1--255. 0 is special value,
238 Default value is: \verb|inherit|.
241 Default value is: \verb|inherit|.
248 It is enabled by default. Note that fixed ttl is incompatible
258 \item \verb|key K| --- use keyed GRE with key \verb|K|. \verb|K| is
267 even do not understand, how it is supposed to work and for what
280 Command \verb|ip tunnel add| is not the only operation,
295 where \verb|Cisco| is name of tunnel device. Command
320 1 & \verb|remote| is \verb|D| and \verb|local| is \verb|S| \\
321 2 & \verb|remote| is \verb|D| and \verb|local| is wildcard \\
322 3 & \verb|remote| is wildcard and \verb|local| is \verb|S| \\
326 If tunnel exists, but it is not in \verb|UP| state, the tunnel is ignored.
327 Note, that if \verb|tunl0| is \verb|UP| it receives all the IPIP packets,
331 source addresses indistinguishable from local ones. It is not so bad idea
347 Essentially, Cisco setup is subset of options, available for Linux.
382 Do not wonder, if your manually configured tunnel is
388 It is possible to set \verb|remote| for GRE tunnel to a multicast
390 tunnel is not quite appropriate in this case, it is rather virtual network).
397 This tunnel is true broadcast network and broadcast packets are
400 if multicast routing is supported in surrounding network, all GRE nodes
402 broadcast network. If multicast routing does not work, it is unpleasant
413 and sent to 128.6.190.2. It is possible to facilitate address resolution
420 Actually, such setup is the most natural for tunneling,
421 it is really flexible, scalable and easily managable, so that
422 it is strongly recommended to be used with GRE tunnels instead of ugly
424 by historical reasons broadcast mode is not supported by IPIP tunnels,
433 example is limiting tunnel bandwidth. The following command:
442 implemented in software and true queue management is impossible for them
443 just because they have no queues. Instead, it is better to create classes
457 it is easy to make with \verb|rsvp| classifier: