Lines Matching defs:of
21 \section{Instead of introduction: micro-FAQ.}
51 work in 2.2.0! Moreover, \verb|route| prints a funny error sort of
63 not to check for consistency of gateway address.
81 A: Linux-2.2 has single module \verb|ipip| for both directions of tunneling
86 only skips some number of hops.
93 and you are not afraid of
98 Q: ... Well, list of things, which 2.0 was able to do finishes.
102 \paragraph{Summary of differences between 2.2 and 2.0.}
107 and got set of 4 devices \verb|tunl0| ... \verb|tunl3| or,
122 but address of peering host, which is directly reachable
142 Standard Linux-2.2 kernel supports three flavor of tunnels,
156 \noindent All the kinds of tunnels are created with one command:
163 it may be even \verb|eth0|. The rest of parameters set
173 \verb|remote <D>| sets remote endpoint of the tunnel to IP
177 packets. It must be an address on another interface of this host.
184 say that they are zero or wildcard. Two tunnels of one mode cannot
198 it with another devices. Certainly, the configuration of tunnels has
202 tunnel setup will result in formation of tunnel loops,
203 collapse of routing or flooding network with exponentially
204 growing number of tunneled fragments is very real.
207 Protocol setup on pointopoint tunnels does not differ of configuration
208 of another devices. You should set a protocol address with \verb|ifconfig|
287 Besides that, you may view list of installed tunnels with the help of command:
295 where \verb|Cisco| is name of tunnel device. Command
347 Essentially, Cisco setup is subset of options, available for Linux.
415 level \verb|arpd| daemon, which will maintain database of hosts attached
422 it is strongly recommended to be used with GRE tunnels instead of ugly
431 Tunnels are devices, hence all the power of Linux traffic control
438 will limit tunneled traffic to 128Kbit with maximal burst size of 4K
445 In general case of dynamic routing you should create such classes
464 If you want to make more detailed classification of sub-flows
466 rooted at \verb|1:ABC| and attach to subroot set of rules parsing