Lines Matching defs:second
51 * The data encode 20 BCD digits which determine the second, minute,
61 * The timecode and reference timestamp are updated once each second
115 * x20 Seconds numbering discrepancy. The decoder second does not match
116 * the IRIG second. This is usually the result of an overdriven
163 #define FIELD 100 /* bits per second */
174 * of the first cycle of the second. The IIR baseband filter phase delay
201 #define IRIG_ERR_CHECK 0x20 /* second numbering discrepancy */
234 int seccnt; /* second interval counter */
266 int second; /* previous second */
268 int frmcnt; /* bit count in second */
441 * runs at the nominal rate of 8000 samples per second,
444 * per second, which results in a frequency change of
466 * Once each second, determine the IRIG format and gain.
832 * frame and ten frames per second.
865 * mark the beginning of the second. The reference time
866 * is the beginning of the second position identifier,
894 * End of second. Decode the timecode and wind
910 &pp->minute, &pp->second) != 8)
914 up->second = (up->second + up->decim) % 60;
924 * the expected second does not agree with the
925 * decoded second, which happens with a garbled
931 if (pp->second != up->second)
933 up->second = pp->second;
950 pp->hour, pp->minute, pp->second,
1009 * This routine is called at the end of each second. It uses the AGC to