include/linux/power_supply.h

351 	int resistance;	/* internal resistance percent */
356 	int ri_uohm;	/* Internal resistance in microohm */
503  * @factory_internal_resistance_uohm: the internal resistance of the battery
504  *   at fabrication time, expressed in microohms. This resistance will vary
506  *   nominal ballpark figure. This internal resistance is given for the state
508  * @factory_internal_resistance_charging_uohm: the internal resistance of the
510  *   The charging process will affect the internal resistance of the battery
511  *   so this value provides a better resistance under these circumstances.
512  *   This resistance will vary depending on the lifetime and charge of the
543  *   expected internal resistance at this temperature. The resistance is given
545  *   resistance of the battery is usually necessary for calculating the open
548  *   by temperature: highest temperature with lowest resistance first, lowest
549  *   temperature with highest resistance last.
552  *   to internal resistance (Ri). The resistance is given in microohm for the
553  *   corresponding voltage in microvolts. The internal resistance is used to
555  *   of the battery. These voltages to resistance tables apply when the battery
562  *   internal resistance characteristics so a separate table is needed.*
566  * @bti_resistance_ohm: The Battery Type Indicator (BIT) nominal resistance
570  * @bti_resistance_tolerance: The tolerance in percent of the BTI resistance,
572  *   tolerance is 10% we will detect a proper battery if the BTI resistance
678  * with an ideal voltage source (V) in series with an internal resistance (Ri)
693  * If we disconnect the load (here simplified as a fixed resistance Rload)
714  * resistance change, and it will affect the VBAT under load, so correlating
821 					      int resistance);