Lines Matching refs:SE
385 #define ASC_IERR_SINGLE_END_DEVICE 0x0020 /* SE device on DIFF bus */
1415 #define DIFF_SENSE 0x0080 /* 1: No SE cables, 0: SE cable (Read-Only) */
1437 #define SE 0x0400 /* SE Device Detect */
1441 #define TERM_SE 0x0030 /* SE Termination Bits */
1442 #define TERM_SE_HI 0x0020 /* Enable SE Upper Termination */
1443 #define TERM_SE_LO 0x0010 /* Enable SE Lower Termination */
1447 #define C_DET_SE 0x0003 /* SE Cable Detect Bits */
1448 #define C_DET1 0x0002 /* Cable Detect for SE Internal Wide */
1449 #define C_DET0 0x0001 /* Cable Detect for SE Internal Narrow */
5082 * LVD device can be attached to SE connector while SE device attached
5083 * to LVD connector. If LVD device attached to SE connector, it only
5088 * SE connectors.
5096 * If either SE or LVD automatic termination control is enabled, then
5104 /* SE automatic termination control is enabled. */
5147 * Clear BIG_ENDIAN, DIS_TERM_DRV, Terminator Polarity and HVD/LVD/SE
5577 * can not be connected to either connector. An LVD device or SE device
5578 * may be connected to either connecor. If an SE device is connected,
5589 * Each function in the ASC-38C1600 uses only the SE cable detect and
5591 * function may use either LVD or SE mode. Corresponding the SE automatic
5593 * function has its own EEPROM. If SE automatic control is enabled for
5603 /* SE automatic termination control is enabled. */
10243 termination = 0; /* auto termination for SE */
10467 termination = 0; /* auto termination for SE */