intel/iwlegacy/common.c

302 	D_INFO("Attempting to send sync command %s\n",
306 	D_INFO("Setting HCMD_ACTIVE for command %s\n",
327 			D_INFO("Clearing HCMD_ACTIVE for command %s\n",
1181 		D_INFO("Defer power set mode while scanning\n");
1770 	D_INFO("Processing response for adding station %u\n", sta_id);
1776 		D_INFO("C_ADD_STA PASSED\n");
1796 	D_INFO("%s station id %u addr %pM\n",
1809 	D_INFO("%s station according to cmd buffer %pM\n",
1840 	D_INFO("Adding sta %u (%pM) %ssynchronously\n", sta_id, sta->sta.addr,
1960 		D_INFO("STA %d already in process of being added.\n", sta_id);
2030 		D_INFO("STA %d already in process of being added.\n", sta_id);
2148 		D_INFO("Unable to remove station %pM, device not ready.\n",
2166 		D_INFO("Removing %pM but non DRIVER active\n", addr);
2171 		D_INFO("Removing %pM but non UCODE active\n", addr);
2210 	D_INFO("Clearing ucode stations in driver\n");
2215 			D_INFO("Clearing ucode active for station %d\n", i);
2223 		D_INFO("No active stations found to be cleared\n");
2247 		D_INFO("Not ready yet, not restoring any stations.\n");
2299 		D_INFO("Restoring all known stations"
2302 		D_INFO("Restoring all known stations" " .... complete.\n");
2378 	D_INFO("Channel %u is not an HT channel\n", il->active.channel);
2381 			D_INFO("idx %d of LQ expects HT channel\n", i);
2434 		D_INFO("init LQ command complete,"
2571 			D_INFO("Rx queue requesting wakeup," " GP1 = 0x%x\n",
2726 			D_INFO("Tx queue %d requesting wakeup," " GP1 = 0x%x\n",
3319 		D_INFO("Clearing HCMD_ACTIVE for command %s\n",
3430 		D_INFO("Geography modes already initialized.\n");
3503 		D_INFO("Channel %d Freq=%d[%sGHz] %s flag=0x%X\n", ch->channel,
3774 		D_INFO("need full RXON - " #cond "\n");	\
3780 		D_INFO("need full RXON - "	\
3962 	D_INFO("Staging channel set to %d [%d]\n", channel, band);
4193 	D_INFO("stop master\n");
4203 	D_INFO("Stop card, put in low power state\n");
4243 	D_INFO("Init card's basic functions\n");
4316 		D_INFO("Failed to init the card\n");
4382 		D_INFO("Deferring tx power set\n");
4415 	D_INFO("BT coex %s\n",
4667 			D_INFO("force reset rejected\n");
4685 		D_INFO("Cancel firmware reload based on "
5152 		D_INFO("Not re-sending same RXON configuration.\n");