media/dvb-frontends/dib9000.c

24 #define dprintk(fmt, arg...) do {					\
266 			dprintk("i2c read error on %d\n", reg);
293 		dprintk("read register %x error\n", reg);
405 /*      dprintk("%d memcmd: %d %d %d\n", state->fe_id, addr, addr+len, len); */
448 		dprintk("could not get the lock\n");
464 		dprintk("could not get the lock\n");
487 	dprintk("going to download %dB of microcode\n", len);
489 		dprintk("error while downloading microcode for RISC %c\n", 'A' + risc_id);
493 	dprintk("Microcode for RISC %c loaded\n", 'A' + risc_id);
519 		dprintk("MBX: init ERROR, no response from RISC %c\n", 'A' + risc_id);
522 	dprintk("MBX: initialized\n");
539 		dprintk("could not get the lock\n");
546 			dprintk("MBX: RISC mbx full, retrying\n");
552 	/*dprintk( "MBX: size: %d\n", size); */
559 	dprintk("--> %02x %d %*ph\n", id, len + 1, len, data);
601 		dprintk("could not get the lock\n");
627 		dprintk("<--\n");
629 			dprintk("%04x\n", d[i]);
630 		dprintk("\n");
633 		dprintk("MBX: message is too big for message cache (%d), flushing message\n", size);
654 		dprintk("%s\n", b);
656 		dprintk("RISC%d: %d.%04d %s\n",
673 /*                      dprintk( "MBX: fetched %04x message to cache\n", *block); */
693 	dprintk("MBX: no free cache-slot found for new message...\n");
713 		dprintk("could not get the lock\n");
722 /*              dprintk( "cleared IRQ: %x\n", tmp); */
757 		dprintk("waiting for message %d timed out\n", id);
777 	dprintk("RISC: ver: %d.%02d (IC: %d)\n", fw_version >> 10, fw_version & 0x3ff, (r[2] << 8) | r[3]);
791 		dprintk("RISC: invalid firmware version");
795 	dprintk("RISC: valid firmware version");
857 		dprintk("wrong Vendor ID (0x%x)\n", value);
863 		dprintk("wrong Device ID (0x%x)\n", value);
869 		dprintk("this driver does not work with DiB7000PC\n");
875 		dprintk("found DiB7000MA/PA/MB/PB\n");
878 		dprintk("found DiB7000HC\n");
881 		dprintk("found DiB7000MC\n");
884 		dprintk("found DiB9000A\n");
887 		dprintk("found DiB9000H\n");
890 		dprintk("found DiB9000M\n");
1020 	/* dprintk( "APB access through rd fw %d %x\n", address, attribute); */
1050 	/* dprintk( "APB access through wr fw %d %x\n", address, attribute); */
1142 		dprintk("error : firmware returned %dbytes needed but the used buffer has only %dbytes\n Firmware init ABORTED", size,
1198 		dprintk("could not get the lock\n");
1541 	dprintk("setting output mode for demod %p to %d\n", fe, mode);
1563 		dprintk("Unhandled output_mode passed to be set for demod %p\n", &state->fe[0]);
1597 				dprintk("TunerITF: read busy\n");
1608 				dprintk("TunerITF: read failed\n");
1616 				dprintk("TunerITF: read more data than expected\n");
1622 				dprintk("TunerITF: write busy\n");
1638 				dprintk("TunerITF: write failed\n");
1683 		dprintk("could not get the lock\n");
1766 	dprintk("gpio dir: %04x: gpio val: %04x\n", st->gpio_dir, st->gpio_val);
1786 		dprintk("pid filter cmd postpone\n");
1794 		dprintk("could not get the lock\n");
1801 	dprintk("PID filter enabled %d\n", onoff);
1816 		dprintk("pid filter postpone\n");
1824 			dprintk("can not add any more pid ctrl cmd\n");
1829 		dprintk("could not get the lock\n");
1832 	dprintk("Index %x, PID %d, OnOff %d\n", id, pid, onoff);
1875 		dprintk("could not get the lock\n");
1906 			dprintk("could not get the lock\n");
1914 			dprintk("TPS lock on the slave%i\n", index_frontend);
2002 		dprintk("dib9000: must specify frequency\n");
2007 		dprintk("dib9000: must specify bandwidth\n");
2013 		dprintk("could not get the lock\n");
2080 		dprintk("tune failed\n");
2087 	dprintk("tune success on frontend%i\n", index_frontend_success);
2176 		dprintk("could not get the lock\n");
2209 		dprintk("could not get the lock\n");
2213 		dprintk("could not get the lock\n");
2244 		dprintk("could not get the lock\n");
2257 		dprintk("could not get the lock\n");
2288 		dprintk("could not get the lock\n");
2327 		dprintk("could not get the lock\n");
2352 		dprintk("could not get the lock\n");
2356 		dprintk("could not get the lock\n");
2383 		dprintk("%s: not enough memory\n", __func__);
2388 		dprintk("%s: not enough memory\n", __func__);
2415 				dprintk("DiB9000 #%d: not identified\n", k);
2424 		dprintk("IC %d initialized (to i2c_address 0x%x)\n", k, new_addr);
2452 		dprintk("set slave fe %p to index %i\n", fe_slave, index_frontend);
2457 	dprintk("too many slave frontend\n");