drivers/atm/lanai.c

69  * Maximum number of VCIs per card.  Setting it lower could theoretically
93  * This is the number of (4 byte) service entries that we will
273 	int nbound;			/* number of bound vccs */
290 	int number;
561 	    lanai->number, offset,
799 			    lvcc->tx.atmvcc->dev->number, lvcc->vci);
853 	    lanai->number);
924 	    lanai->number, address);
967 		    "(wanted 0x%02X, got 0x%02X)\n", lanai->number,
974 		    "bad (wanted 0x%02X, got 0x%02X)\n", lanai->number,
983 			    "(0x%02X, inverse 0x%02X)\n", lanai->number,
989 	/* Verify serial number */
994 		    "don't match (0x%08X, inverse 0x%08X)\n", lanai->number,
998 	DPRINTK("eeprom: Serial number = %d\n", (unsigned int) lanai->serialno);
999 	/* Verify magic number */
1004 		    "don't match (0x%08X, inverse 0x%08X)\n", lanai->number,
1008 	DPRINTK("eeprom: Magic number = 0x%08X\n", lanai->magicno);
1012 		    lanai->number, (unsigned int) lanai->magicno,
1082 			status_message(lanai->number, name, new & flag)
1102 		    "%d\n", lanai->number, result);
1113 		    "%d\n", lanai->number, result);
1118 			pcistatus_got(lanai->number, name); \
1258 			    "always busy!\n", lanai->number);
1275  * space available.  "pdusize" is the number of bytes the PDU will take
1402 		    lvcc->rx.atmvcc->dev->number, lvcc->vci, size, n);
1491 		    "for %s buffer, got only %zu\n", lanai->number, size,
1563 	    "implemented\n", lanai->number);
1625 		    "vcc %d\n", lanai->number, (unsigned int) s, vci);
1636 			    "vcc %d\n", lanai->number, (unsigned int) s, vci);
1648 		    "vcc %d\n", lanai->number, (unsigned int) s, vci);
1655 		    "vcc %d\n", lanai->number, (unsigned int) s, vci);
1684 		    "PDU on VCI %d!\n", lanai->number, vci);
1827 		    lanai->number, (unsigned int) (reason & INT_DMASHUT),
1835 		    lanai->number);
1843 		    lanai->number);
1848 		    "segmentation shutdown, reason=0x%08X\n", lanai->number,
1856 		    lanai->number,
1937 		    "PCI device", lanai->number);
1943 		    "(itf %d): No suitable DMA available.\n", lanai->number);
1953 		    "PCI_LATENCY_TIMER: %d\n", lanai->number, result);
2045  * CBR ICG is stored as a fixed-point number with 4 fractional bits.
2046  * Note that storing a number greater than 2046.0 will result in
2062  * The end result is supposed to be a fixed-point number with FRAC_BITS
2114 	lanai->number = atmdev->number;
2217 		"(%pMF)\n", lanai->number, (int) lanai->pci->revision,
2220 	    "board_rev=%d\n", lanai->number,
2252 	    lanai->number);
2327 	DPRINTK(DEV_LABEL "(itf %d): open %d.%d\n", lanai->number,
2450 		    atmdev->number, lanai->type==lanai2 ? "2" : "HB",