usb/controller/musb_otg.c

213 		/* control endpoint */
383 	/* select endpoint 0 */
504 	/* select endpoint 0 */
592 /* Control endpoint only data handling functions (RX/TX/SYNC) */
606 	/* select endpoint 0 */
748 	/* select endpoint 0 */
876 	/* select endpoint 0 */
1055 	/* select endpoint */
1220 	/* select endpoint 0 */
1265 	/* select endpoint 0 */
1353 	/* select endpoint 0 */
1423 	/* select endpoint */
1571 	/* select endpoint */
1704 	/* select endpoint */
1729 		/* Protocol, speed, device endpoint */
1923 	/* select endpoint */
2075 	/* Protocol, speed, device endpoint */
2177 			/* complete root HUB interrupt endpoint */
2188 			/* complete root HUB interrupt endpoint */
2202 	/* complete root HUB interrupt endpoint */
2318 		/* complete root HUB interrupt endpoint */
2321 	/* check for any endpoint interrupts */
2324 		DPRINTFN(4, "real endpoint interrupt "
2395 	xfer_type = xfer->endpoint->edesc->bmAttributes & UE_XFERTYPE;
2447 		td->toggle = xfer->endpoint->toggle_next;
2567 			 * endpoint direction.
2604 	 * Only enable the endpoint interrupt when we are
2649 		DPRINTFN(14, "enabled interrupts on endpoint\n");
2690 		xfer->endpoint->toggle_next = td->toggle;
2747 	DPRINTFN(12, "xfer=%p endpoint=%p transfer done\n",
2748 	    xfer, xfer->endpoint);
2799 	DPRINTFN(1, "xfer=%p, endpoint=%p, error=%d\n",
2800 	    xfer, xfer->endpoint, error);
2802 	DPRINTFN(14, "disabled interrupts on endpoint\n");
2823 	DPRINTFN(4, "endpoint=%p\n", ep);
2834 	/* select endpoint */
2858 	/* select endpoint */
2878 		/* Configure endpoint */
2939 		/* Configure endpoint */
3003 	DPRINTFN(4, "endpoint=%p\n", ep);
3015 	/* get endpoint descriptor */
3018 	/* reset endpoint */
3107 	/* select endpoint index 0 */
3119 	/* these numbers exclude the control endpoint */
3144 	/* initialise endpoint profiles */
3151 		/* select endpoint */
3437 	    xfer, xfer->endpoint->isoc_next, xfer->nframes);
3447 	temp = (nframes - xfer->endpoint->isoc_next) & MUSB2_MASK_FRAME;
3455 	if ((xfer->endpoint->is_synced == 0) ||
3463 		xfer->endpoint->isoc_next = (nframes + 3) & MUSB2_MASK_FRAME;
3464 		xfer->endpoint->is_synced = 1;
3465 		DPRINTFN(2, "start next=%d\n", xfer->endpoint->isoc_next);
3471 	temp = (xfer->endpoint->isoc_next - nframes) & MUSB2_MASK_FRAME;
3481 	xfer->endpoint->isoc_next += fs_frames;
4119 	 * Check for a valid endpoint profile in USB device mode:
4182 	DPRINTFN(2, "endpoint=%p, addr=%d, endpt=%d, mode=%d (%d)\n",