dev/bxe/bxe_elink.c

4277 		ELINK_DEBUG_P3(sc, "req_flow_ctrl %x, req_line_speed %x,"
5702 	ELINK_DEBUG_P3(sc, "link_status 0x%x  phy_link_up %x int_mask 0x%x\n",
5704 	ELINK_DEBUG_P3(sc, "line_speed %x  duplex %x  flow_ctrl 0x%x\n",
6484 	ELINK_DEBUG_P3(sc, "gp_status 0x%x, is_link_up %d, speed_mask 0x%x\n",
6534 	ELINK_DEBUG_P3(sc, "duplex %x  flow_ctrl 0x%x link_status 0x%x\n",
6613 			ELINK_DEBUG_P3(sc, " ELINK_SINGLE_MEDIA_DIRECT duplex %x  flow_ctrl 0x%x link_status 0x%x\n",
6617 	ELINK_DEBUG_P3(sc, "duplex %x  flow_ctrl 0x%x link_status 0x%x\n",
6673 	ELINK_DEBUG_P3(sc, "duplex %x  flow_ctrl 0x%x link_status 0x%x\n",
6938 	ELINK_DEBUG_P3(sc, "port %x, is_xgxs %x, int_status 0x%x\n", port,
6941 	ELINK_DEBUG_P3(sc, " int_mask 0x%x, MI_INT %x, SERDES_LINK %x\n",
7709 	ELINK_DEBUG_P3(sc, "port %x, XGXS?%x, int_status 0x%x\n",
7713 	ELINK_DEBUG_P3(sc, "int_mask 0x%x MI_INT %x, SERDES_LINK %x\n",
7838         ELINK_DEBUG_P3(sc, "vars : phy_flags = %x, mac_type = %x, phy_link_up = %x\n",
7840         ELINK_DEBUG_P3(sc, "vars : link_up = %x, line_speed = %x, duplex = %x\n",
7842         ELINK_DEBUG_P3(sc, "vars : flow_ctrl = %x, ieee_fc = %x, link_status = %x\n",
7844         ELINK_DEBUG_P3(sc, "vars : eee_status = %x, fault_detected = %x, check_kr2_recovery_cnt = %x\n",
7846         ELINK_DEBUG_P3(sc, "vars : periodic_flags = %x, aeu_int_mask = %x, rx_tx_asic_rst = %x\n",
7861 	ELINK_DEBUG_P3(sc, "vars->flow_ctrl = 0x%x, vars->link_status = 0x%x,"
7898 		ELINK_DEBUG_P3(sc, "ext_phy_link_up = %d, int_link_up = %d,"
7968 	ELINK_DEBUG_P3(sc, "FW version 0x%x:0x%x for port %d\n",
8475 	ELINK_DEBUG_P3(sc, "KR PMA status 0x%x->0x%x,"
8695 	ELINK_DEBUG_P3(sc, "Setting transmitter tx_en=%x for port %x "
9455 		ELINK_DEBUG_P3(sc, "Set fault module-detected led "
9769 	ELINK_DEBUG_P3(sc, "8706/8726 rx_sd 0x%x pcs_status 0x%x 1Gbps"
13121 		ELINK_DEBUG_P3(sc, "media_type = %x, flags = %x, supported = %x\n",
13152 	ELINK_DEBUG_P3(sc, "Internal phy port=%d, addr=0x%x, mdio_ctl=0x%x\n",
13280 	ELINK_DEBUG_P3(sc, "phy_type 0x%x port %d found in index %d\n",
13323 	ELINK_DEBUG_P3(sc,
13373 	ELINK_DEBUG_P3(sc, "Requested Duplex = %x, line_speed = %x, flow_ctrl = %x\n",
13433 		ELINK_DEBUG_P3(sc, "phy_config_swapped %x, phy_index %x,"
13982 	ELINK_DEBUG_P3(sc, " params : port = %x, loopback_mode = %x req_duplex = %x\n",
13984         ELINK_DEBUG_P3(sc, " params : switch_cfg = %x, lane_config = %x req_duplex[1] = %x\n",
13986         ELINK_DEBUG_P3(sc, " params : chip_id = %x, feature_config_flags = %x, num_phys = %x\n",
13988         ELINK_DEBUG_P3(sc, " params : rsrv = %x, eee_mode = %x, hw_led_mode = x\n",
13990         ELINK_DEBUG_P3(sc, " params : multi_phy = %x, req_fc_auto_adv = %x, link_flags = %x\n",
14726 	ELINK_DEBUG_P3(sc, "Link changed:[%x %x]->%x\n", vars->link_up,
15102 	ELINK_DEBUG_P3(sc, "Setting MOD_ABS (GPIO%d_P%d) AEU to 0x%x\n",