Lines Matching defs:rate
122 #define MATCH_RATE 0x00008 /* rate set mismatch */
271 ("rate set too large: %u", sp->rates[1]));
774 * rate by channel width.
781 * map it to the highest MCS rate.
851 /* best/max rate preferred if signal level close enough XXX */
867 * Check rate set suitability and return the best supported rate.
892 * Check any fixed rate is included.
973 uint8_t rate;
1069 rate = check_rate(vap, se->se_chan, se);
1070 if (rate & IEEE80211_RATE_BASIC) {
1073 * An 11b-only ap will give a rate mismatch if there is an
1074 * OFDM fixed tx rate for 11g. Try downgrading the channel
1075 * in the scan list to 11b and retry the rate check.
1078 rate = check_rate(vap, demote11b(vap, se->se_chan), se);
1079 if ((rate & IEEE80211_RATE_BASIC) == 0) {
1084 } else if (rate < 2*24) {
1091 * NB: we cheat a bit here by looking at the max rate;
1132 printf(" %2dM%c", (rate & IEEE80211_RATE_VAL) / 2,
1190 "macaddr bssid chan rssi rate flag wep essid");
1307 roamRate = vap->iv_roamparms[mode].rate;
1372 * If rate control is enabled check periodically to see if
1623 * "correct" rate control capabilities being