Lines Matching defs:rate
201 * Install default tx rate handling: no fixed rate, lowest
202 * supported rate for mgmt and multicast frames. Default
212 * Setting the management rate to MCS 0 assumes that the
213 * BSS Basic rate set is empty and the BSS Basic MCS set
217 * defined rate for this mode.
402 const uint8_t *buf, int len, int rate, int rssi)
461 if (rate >= 0)
462 printf(" %dM", rate / 2);
504 * Workaround awkwardness with fixed rate. We are called
505 * to check both the legacy rate set and the HT rate set
506 * but we must apply any legacy fixed rate check only to the
507 * legacy rate set and vice versa. We cannot tell what type
508 * of rate set we've been given (legacy or HT) but we can
509 * distinguish the fixed rate type (MCS have 0x80 set).
511 * check MCS or legacy rate using the flags and we use the
512 * type of any fixed rate to avoid applying an MCS to a
513 * legacy rate and vice versa.
528 * we must use the appropriate basic rate set or chaos will
555 * Check for fixed rate.
566 * A rate in the node's rate set is not
567 * supported. If this is a basic rate and we
569 * Otherwise we just discard/ignore the rate.
576 * Overwrite with the supported rate
577 * value so any basic rate bit is set.
657 * Check if the specified rate set supports ERP.
658 * NB: the rate set is assumed to be sorted.
684 * Mark the basic rates for the rate table based on the
722 * Set the basic rates in a rate set.
732 * Add basic rates to a rate set.