# bcm94712agr board with sdram as l2 switch.
# Copyright 2006, Broadcom Corporation
# All Rights Reserved.
# 
# THIS SOFTWARE IS OFFERED "AS IS", AND BROADCOM GRANTS NO WARRANTIES OF ANY
# KIND, EXPRESS OR IMPLIED, BY STATUTE, COMMUNICATION OR OTHERWISE. BROADCOM
# SPECIFICALLY DISCLAIMS ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS
# FOR A SPECIFIC PURPOSE OR NONINFRINGEMENT CONCERNING THIS SOFTWARE.
# $Id: bcm94712agr-sd-sw.txt,v 1.1.1.1 2008/10/15 03:25:52 james26_jang Exp $
boardtype=0x0451
boardnum=${serno}
# Board revision 3.3
boardrev=0x33
boardflags=0x0288
sromrev=2

# MIPS clock frequency in MHz
clkfreq=200

# 16 MB SDR SDRAM (4 Meg x 16 x 2)
sdram_init=0
sdram_config=0x0022
sdram_refresh=0x0000
sdram_ncdl=0

# Ethernet w/Admtek switch
et0macaddr=00:90:4c:76:${maclo}
et0phyaddr=30
et0mdcport=0

# ADMTek switch mgmt i/f GPIO mapping
gpio5=adm_rc

# No eth1
et1phyaddr=0x1f

# Make the d11 i/f single band
wl0id=0x4320

# 4712 802.11g parameters
il0macaddr=00:90:4c:75:${maclo}
aa0=3
ag0=2
pa0maxpwr=60
pa0itssit=62
pa0b0=0x1486
pa0b1=0xfaa8
pa0b2=0xfe47

# Wireless LED GPIO mapping/behavior
wl0gpio2=0

# Commons wireless parameters
cctl=0
ccode=0

# Bootlaoder variables
dl_ram_addr=a0001000
os_ram_addr=80001000
os_flash_addr=bfc40000
lan_ipaddr=192.168.1.1
lan_netmask=255.255.255.0
scratch=a0180000
boot_wait=on
reset_gpio=7

# Watchdog timer in ms
watchdog=3000

# glue between bootloader and firmware
landevs=et0 wl0 wl1
wandevs=