1#
2# Specific board setup for the Engenius ENH-200 802.11bgn mesh node.
3#
4# The Engenius ENH-200 has the following hardware:
5#
6# + AR7240 CPU SoC
7# + AR9285 Wifi
8# + Integrated switch
9# + 8MB flash
10# + 32MB RAM
11# + uboot environment
12
| 1#
2# Specific board setup for the Engenius ENH-200 802.11bgn mesh node.
3#
4# The Engenius ENH-200 has the following hardware:
5#
6# + AR7240 CPU SoC
7# + AR9285 Wifi
8# + Integrated switch
9# + 8MB flash
10# + 32MB RAM
11# + uboot environment
12
|
13# $FreeBSD: head/sys/mips/conf/ENH200 291049 2015-11-19 01:58:12Z imp $
| 13# $FreeBSD: head/sys/mips/conf/ENH200 295945 2016-02-24 00:39:36Z sobomax $
|
14
15#NO_UNIVERSE
16
17include "AR724X_BASE"
18ident "ENH200"
19hints "ENH200.hints"
20
21options AR71XX_REALMEM=32*1024*1024
22
23options AR71XX_ENV_UBOOT
24
25# For DOS - enable if required
26options MSDOSFS
27
28# uncompress - to boot read-only lzma natively from flash
| 14
15#NO_UNIVERSE
16
17include "AR724X_BASE"
18ident "ENH200"
19hints "ENH200.hints"
20
21options AR71XX_REALMEM=32*1024*1024
22
23options AR71XX_ENV_UBOOT
24
25# For DOS - enable if required
26options MSDOSFS
27
28# uncompress - to boot read-only lzma natively from flash
|
29device geom_uncompress
30options GEOM_UNCOMPRESS
31options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uncompress\"
| 29device geom_uzip
30options GEOM_UZIP
31options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uzip\"
|
32
33# Used for the static uboot partition map
34device geom_map
35
36# Options needed for the EEPROM based calibration/PCI configuration data.
37options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash
38options ATH_EEPROM_FIRMWARE # Use EEPROM from flash
39device firmware # Used by the above
40
41# Options required for miiproxy and mdiobus
42options ARGE_MDIO # Export an MDIO bus separate from arge
43device miiproxy # MDIO bus <-> MII PHY rendezvous
44
45device etherswitch
46device arswitch
| 32
33# Used for the static uboot partition map
34device geom_map
35
36# Options needed for the EEPROM based calibration/PCI configuration data.
37options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash
38options ATH_EEPROM_FIRMWARE # Use EEPROM from flash
39device firmware # Used by the above
40
41# Options required for miiproxy and mdiobus
42options ARGE_MDIO # Export an MDIO bus separate from arge
43device miiproxy # MDIO bus <-> MII PHY rendezvous
44
45device etherswitch
46device arswitch
|