1#
2# Specific board setup for the Atheros AP96 reference board.
3#
4# The AP96 has the following hardware:
5#
6# + AR7161 CPU SoC
7# + AR9223 2.4GHz 11n
8# + AR9220 5GHz 11n
9# + AR8316 10/100/1000 switch
10# + m25p64 based 8MB flash
11# + 64mb RAM
12# + uboot environment
13
| 1#
2# Specific board setup for the Atheros AP96 reference board.
3#
4# The AP96 has the following hardware:
5#
6# + AR7161 CPU SoC
7# + AR9223 2.4GHz 11n
8# + AR9220 5GHz 11n
9# + AR8316 10/100/1000 switch
10# + m25p64 based 8MB flash
11# + 64mb RAM
12# + uboot environment
13
|
14# $FreeBSD: head/sys/mips/conf/AP96 239757 2012-08-27 21:49:37Z adrian $
| 14# $FreeBSD: head/sys/mips/conf/AP96 263301 2014-03-18 14:41:18Z imp $
|
15
16include "AR71XX_BASE"
17ident "AP96"
18hints "AP96.hints"
19
| 15
16include "AR71XX_BASE"
17ident "AP96"
18hints "AP96.hints"
19
|
20options AR71XX_REALMEM=64*1024*1024
| 20options AR71XX_REALMEM=64*1024*1024
|
21
| 21
|
22options AR71XX_ENV_UBOOT
| 22options AR71XX_ENV_UBOOT
|
23
24# For DOS - enable if required
25options MSDOSFS
26
27# uncompress - to boot read-only lzma natively from flash
28device geom_uncompress
| 23
24# For DOS - enable if required
25options MSDOSFS
26
27# uncompress - to boot read-only lzma natively from flash
28device geom_uncompress
|
29options GEOM_UNCOMPRESS
30options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uncompress\"
| 29options GEOM_UNCOMPRESS
30options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uncompress\"
|
31
32# Used for the static uboot partition map
33device geom_map
34
35# Options needed for the EEPROM based calibration/PCI configuration data.
36options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash
37options ATH_EEPROM_FIRMWARE # Use EEPROM from flash
38device firmware # Used by the above
39
40# Options required for miiproxy and mdiobus
41options ARGE_MDIO # Export an MDIO bus separate from arge
42device miiproxy # MDIO bus <-> MII PHY rendezvous
43
44device etherswitch
45device arswitch
| 31
32# Used for the static uboot partition map
33device geom_map
34
35# Options needed for the EEPROM based calibration/PCI configuration data.
36options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash
37options ATH_EEPROM_FIRMWARE # Use EEPROM from flash
38device firmware # Used by the above
39
40# Options required for miiproxy and mdiobus
41options ARGE_MDIO # Export an MDIO bus separate from arge
42device miiproxy # MDIO bus <-> MII PHY rendezvous
43
44device etherswitch
45device arswitch
|